[U-Boot] [PATCH 1/3] arm: mx6: cm-fx6: force host mode on usb controller

[Igor Grinberg <grinberg@compulab.co.il>]

On 08/30/15 15:36, Nikita Kiryanov wrote:
> On some CM-FX6 modules U-Boot attempts to configure the usb0 controller in
> device mode, which renders it unavailable:
> 	USB0:   Port not available.
> and also causes usb stop to report an error
> 	EHCI failed to shut down host controller.
> 
> This happens mostly on MX6 Dual based modules, and is caused by the USBPHY_CTRL
> register reporting USBPHY_CTRL_OTG_ID to be 1, even when it is pulled down.
> Since we do not support device mode in cm-fx6 u-boot, force all controllers to
> be configured as hosts.
> 
> Cc: Stefano Babic <sbabic@denx.de>
> Cc: Igor Grinberg <grinberg@compulab.co.il>
> Signed-off-by: Nikita Kiryanov <nikita@compulab.co.il>

Acked-by: Igor Grinberg <grinberg@compulab.co.il>

> ---
>  board/compulab/cm_fx6/cm_fx6.c | 6 ++++++
>  1 file changed, 6 insertions(+)
> 
> diff --git a/board/compulab/cm_fx6/cm_fx6.c b/board/compulab/cm_fx6/cm_fx6.c
> index def821c..668d221 100644
> --- a/board/compulab/cm_fx6/cm_fx6.c
> +++ b/board/compulab/cm_fx6/cm_fx6.c
> @@ -14,6 +14,7 @@
>  #include <miiphy.h>
>  #include <netdev.h>
>  #include <errno.h>
> +#include <usb.h>
>  #include <fdt_support.h>
>  #include <sata.h>
>  #include <splash.h>
> @@ -349,6 +350,11 @@ static int cm_fx6_setup_usb_otg(void)
>  	return gpio_direction_output(SB_FX6_USB_OTG_PWR, 0);
>  }
>  
> +int board_usb_phy_mode(int port)
> +{
> +	return USB_INIT_HOST;
> +}
> +
>  int board_ehci_hcd_init(int port)
>  {
>  	int ret;
> 

-- 
Regards,
Igor.