From mboxrd@z Thu Jan 1 00:00:00 1970 From: Igor Grinberg Date: Sun, 30 Aug 2015 16:33:05 +0300 Subject: [U-Boot] [PATCH 1/3] arm: mx6: cm-fx6: force host mode on usb controller In-Reply-To: <1440938209-1731-2-git-send-email-nikita@compulab.co.il> References: <1440938209-1731-1-git-send-email-nikita@compulab.co.il> <1440938209-1731-2-git-send-email-nikita@compulab.co.il> Message-ID: <55E30611.1080308@compulab.co.il> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 08/30/15 15:36, Nikita Kiryanov wrote: > On some CM-FX6 modules U-Boot attempts to configure the usb0 controller in > device mode, which renders it unavailable: > USB0: Port not available. > and also causes usb stop to report an error > EHCI failed to shut down host controller. > > This happens mostly on MX6 Dual based modules, and is caused by the USBPHY_CTRL > register reporting USBPHY_CTRL_OTG_ID to be 1, even when it is pulled down. > Since we do not support device mode in cm-fx6 u-boot, force all controllers to > be configured as hosts. > > Cc: Stefano Babic > Cc: Igor Grinberg > Signed-off-by: Nikita Kiryanov Acked-by: Igor Grinberg > --- > board/compulab/cm_fx6/cm_fx6.c | 6 ++++++ > 1 file changed, 6 insertions(+) > > diff --git a/board/compulab/cm_fx6/cm_fx6.c b/board/compulab/cm_fx6/cm_fx6.c > index def821c..668d221 100644 > --- a/board/compulab/cm_fx6/cm_fx6.c > +++ b/board/compulab/cm_fx6/cm_fx6.c > @@ -14,6 +14,7 @@ > #include > #include > #include > +#include > #include > #include > #include > @@ -349,6 +350,11 @@ static int cm_fx6_setup_usb_otg(void) > return gpio_direction_output(SB_FX6_USB_OTG_PWR, 0); > } > > +int board_usb_phy_mode(int port) > +{ > + return USB_INIT_HOST; > +} > + > int board_ehci_hcd_init(int port) > { > int ret; > -- Regards, Igor.