[U-Boot] [PATCHv2] arm: socfpga: Add support for the Terasic DE-0 Atlas board

[Sinan Akman <sinan@writeme.com>]

On 02/09/15 10:18 AM, Dinh Nguyen wrote:
>
>
> On 9/2/15 3:18 AM, Marek Vasut wrote:
>> On Wednesday, September 02, 2015 at 12:41:52 AM, dinguyen at opensource.altera.com
>> wrote:
>>> From: Dinh Nguyen <dinguyen@opensource.altera.com>
>>>
>>> Add support for the Terasic DE0-Nano/Atlas-SoC Kit, which is a CycloneV
>>> based board. The board can boot from SD/MMC. Ethernet is also supported.
>>>
>>> Signed-off-by: Dinh Nguyen <dinguyen@opensource.altera.com>
>>> ---
>>> v2: add ethernet support
>>>      moved board files to board/terasic/de0-nano-soc/
>>>      associate everything with 'de0-nano-soc' or 'de0_nano_soc'
>>>      based on u-boot-socfpga/wip/boards branch
>>
>> Applied to wip/boards, thanks. I shuffled the order in arch/arm/mach-
>> socfpga/Kconfig so that things are sorted properly. Can you please
>> double-check that everything builds for you ?
>>
>
> Yes, everything builds for me. Thanks!

   Hi Dinh

   FYI, I just pulled from  wip/boards and built with
socfpga_de0_nano_soc_defconfig and booted from SD :

U-Boot SPL 2015.10-rc2-00311-g859de28-dirty (Sep 02 2015 - 14:47:55) 

drivers/ddr/altera/sequencer.c: Preparing to start memory calibration 

drivers/ddr/altera/sequencer.c: CALIBRATION PASSED 

drivers/ddr/altera/sequencer.c: Calibration complete 

bad magic 

spl: mmc: no boot mode left to try 

### ERROR ### Please RESET the board ###

   Not sure what I have missed.

   Regards
   Sinan Akman