[U-Boot] [U-Boot, 1/4, v2] mtd: nand: fsmc: Add BCH4 SW ECC support for SPEAr600

[Stefan Roese <sr@denx.de>]

On 12.09.2015 17:20, Tom Rini wrote:
> On Sat, Sep 12, 2015 at 09:46:51AM -0500, Scott Wood wrote:
>> On Sat, 2015-09-12 at 10:46 -0400, Tom Rini wrote:
>>> On Sat, Sep 12, 2015 at 09:36:54AM -0500, Scott Wood wrote:
>>>> On Sat, 2015-09-12 at 08:50 -0400, Tom Rini wrote:
>>>>> On Wed, Sep 02, 2015 at 02:29:12PM +0200, Stefan Roese wrote:
>>>>>
>>>>>> This patch adds support for 4-bit ECC BCH4 for the SPEAr600 SoC. This
>>>>>> can
>>>>>> be used by boards equipped with a NAND chip that requires 4-bit ECC
>>>>>> strength.
>>>>>> The SPEAr600 HW ECC only supports 1-bit ECC strength.
>>>>>>
>>>>>> To enable SW BCH4, you need to specify this in your config header:
>>>>>>
>>>>>> #define CONFIG_NAND_ECC_BCH
>>>>>> #define CONFIG_BCH
>>>>>>
>>>>>> And use the command "nandecc bch4" to select this ECC scheme upon
>>>>>> runtime.
>>>>>>
>>>>>> Tested on SPEAr600 x600 board.
>>>>>>
>>>>>> Signed-off-by: Stefan Roese <sr@denx.de>
>>>>>> Cc: Scott Wood <scottwood@freescale.com>
>>>>>> Acked-by: Viresh Kumar <viresh.kumar@linaro.org>
>>>>>
>>>>> Applied to u-boot/master, thanks!
>>>>>
>>>>
>>>> There's a v3, and some minor comments even on that one...
>>>
>>> Mutter, sorry.  Would you rather a revert of the series or just
>>> incremental on top?
>>
>> Either is fine -- I just wanted to make sure it didn't get forgotten.
>
> OK, Stefan, please do an incremental on top of master now to cover
> what's been noted in v3, thanks!

Sure.

Thanks,
Stefan