[U-Boot] [PATCH V3 0/4] Fix fdt 'reg' parsing and unbreak few Exynos4 boards

[Przemyslaw Marczak <p.marczak@samsung.com>]

Hello Tom, Simon,

On 09/30/2015 03:13 PM, Tom Rini wrote:
> On Wed, Sep 30, 2015 at 01:14:49PM +0200, Przemyslaw Marczak wrote:
>
>> Booting of Odroid U3/X2 with SD card, ends with error:
>>
>> MMC:   EXYNOS DWMMC: 0
>> Card did not respond to voltage select!
>> *** Warning - MMC init failed, using default environment
>>
>> Generally this was broken, because of wrong addresses,
>> assigned to GPIOs.
>> The source of the problem was in rework of lib/fdtdec.c, after which
>> function fdtdec_get_addr() doesn't work as previous and function
>> dev_get_addr() doesn't works as expected.
>>
>> The code after rework in lib/fdtdec.c assumed, that #size-cells property,
>> should be always greater or equal to 1, this was wrong, because it can be 0.
>>
>> In case of debugging the issue, I found, that mmc clock was computed wrong,
>> for Exynos4, because of function get_mmc_clk(), which always returns -1 for
>> this SoC.
>>
>> The patchset should fix booting on all Exynos4 boards, however it was tested
>> on: Odroid X2 / U3 / XU3 and Trats / Trats2.
>>
>> Przemyslaw Marczak (4):
>>    fdtdec: fix parsing 'reg' property with zero value in '#size-cells'
>>    gpio: s5p: call: dev_get_addr() instead of fdtdec_get_addr()
>>    mach-exynos: clock: restore calling dead exynos4_get_mmc_clk()
>>    trats: fdt: disable unused DW MMC
>>
>>   arch/arm/dts/exynos4210-trats.dts |  4 ++++
>>   arch/arm/mach-exynos/clock.c      | 10 ++++------
>>   drivers/gpio/s5p_gpio.c           | 18 +++++++++++-------
>>   lib/fdtdec.c                      |  2 +-
>>   4 files changed, 20 insertions(+), 14 deletions(-)
>
> Should I grab this directly or expect a PR from the DT or Samsung tree?
> Thanks!
>

If this is not a problem for you, then it will be nice :)

Simon,
Is that good to you?

Best regards,
-- 
Przemyslaw Marczak
Samsung R&D Institute Poland
Samsung Electronics
p.marczak at samsung.com