From mboxrd@z Thu Jan  1 00:00:00 1970
From: Nitin Garg <nitin.garg@freescale.com>
Date: Fri, 9 Oct 2015 10:08:56 -0500
Subject: [U-Boot] mx6qp sabreauto hangs after saveenv/reset
In-Reply-To: <CAOMZO5Dtw0T-5u7HdxpP=Fmw4gR4ZJM2noDbLjFud_afy-1TUQ@mail.gmail.com>
References: <CAOMZO5C-7inaPxPkdOQMsL-w=Xfyxyh6GWm7QPWm_uwvmq3Mrg@mail.gmail.com>
 <20151009021224.GA10858@shlinux2>
 <CAOMZO5Dtw0T-5u7HdxpP=Fmw4gR4ZJM2noDbLjFud_afy-1TUQ@mail.gmail.com>
Message-ID: <5617D888.60305@freescale.com>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

On 10/09/2015 09:59 AM, Fabio Estevam wrote:
> Hi Peng,
> 
> On Thu, Oct 8, 2015 at 11:12 PM, Peng Fan <b51431@freescale.com> wrote:
> 
>> Whether plugging nand chip into the socket or without nand chip, the board reboot
>> well in my side. I did not do stress test, only do a few test, and each time
>> 'reset', it can boot fine.
> 
> Thanks for testing it.
> 
> Maybe it is an issue with the board I have. I should receive a new one
> next week and will test it.
> 
> By the way, does your board work standalone (without the base board)?
> Mine only works when it is connected to the base board and in this
> case I need to supply 12V.
> 
> Thanks
> 
There is a jumper (J2) to change it to standalone. 
Mine works without baseboard and 5V supply.

-Nitin