[U-Boot] [PATCH] mtd: nand: vf610_nfc: resync with upstream Linux version

[Stefano Babic <sbabic@denx.de>]

On 15/10/2015 06:00, Scott Wood wrote:
> On Wed, 2015-10-14 at 13:27 +0200, Albert ARIBAUD wrote:
>> On Wed, 14 Oct 2015 13:21:41 +0200, Albert ARIBAUD (3ADEV)
>> <albert.aribaud@3adev.fr> wrote:
>>> Hello Stefan,
>>>
>>> On Tue, 13 Oct 2015 22:11:42 -0700, Stefan Agner <stefan@agner.ch>
>>> wrote:
>>>> This resyncs the driver changes with the Linux version of the
>>>> driver. The driver received some feedback in the LKML and got
>>>> recently acceppted, the latest version can be found here:
>>>> https://lkml.org/lkml/2015/9/2/678
>>>>
>>>> Notable changes are:
>>>> - On ECC error, reread OOB and count bit flips in OOB too.
>>>>   If flipped bits are below threshold, also return an empty
>>>>   OOB buffer.
>>>> - Return the amount of bit flips in vf610_nfc_read_page.
>>>> - Use endianness aware vf610_nfc_read to read ECC status.
>>>> - Do not enable IDLE IRQ (since we do not operate with an
>>>>   interrupt service routine).
>>>> - Use type safe struct for buffer variants (vf610_nfc_alt_buf).
>>>> - Renamed variables in struct vf610_nfc (column and page_sz)
>>>>   to reflect better what they really representing.
>>>>
>>>> The U-Boot version currently does not support RAW NAND write
>>>> when using the HW ECC engine.
>>>>
>>>> Signed-off-by: Bhuvanchandra DV <bhuvanchandra.dv@toradex.com>
>>>> Signed-off-by: Stefan Agner <stefan@agner.ch>
>>>
>>> Tested-by: Albert ARIBAUD (3ADEV) <albert.aribaud@3adev.fr>
>>
>> Putting Stefano Babic in To: list since this is IMX-like stuff.
>>
>> Stefano,
>>
>> I can pick this plus Stefan's other two and Anthony's vf610-related
>> patches if you want, or you can. Either way, Tom will take them as they
>> are essentially bugfixes.
>
> Acked-by: Scott Wood <scottwood@freescale.com>
>


Thanks Scott. I am picking this one and a couple of other patches and I
will send my PR to Tom.

Best regards,
Stefano



-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================