[U-Boot] [PATCH v3 0/8] dm: pci: tegra: Convert Tegra PCI to driver model

[Stephen Warren <swarren@wwwdotorg.org>]

On 11/12/2015 09:57 AM, Simon Glass wrote:
> This series converts all Tegra boards to use driver model for PCI. The net
> effect should be no change in functionality.

I applied this series on top of current u-boot/master.

On Jetson TK1 (T124), I see the following errors when U-Boot starts:

> Net:   ERROR: tegra-pcie: failed to power on PHY: -110
>
> at /home/swarren/shared/git_wa/tegra-uboot-flasher/u-boot/drivers/pci/pci_tegra.c:685/tegra_pcie_enable_controller()
> ERROR: tegra-pcie: failed to enable controller
> at /home/swarren/shared/git_wa/tegra-uboot-flasher/u-boot/drivers/pci/pci_tegra.c:997/pci_tegra_probe()
> No ethernet found.

I assume you can investigate that without issue, since you have that board.

On Jetson TX1 (T210), you need to squash the following into the final 
commit of the series:

> diff --git a/drivers/pci/pci_tegra.c b/drivers/pci/pci_tegra.c
> index ecd4313501c4..f88bd0d2858b 100644
> --- a/drivers/pci/pci_tegra.c
> +++ b/drivers/pci/pci_tegra.c
> @@ -1022,6 +1022,7 @@ static const struct udevice_id pci_tegra_ids[] = {
>  	{ .compatible = "nvidia,tegra20-pcie", .data = TEGRA20_PCIE },
>  	{ .compatible = "nvidia,tegra30-pcie", .data = TEGRA30_PCIE },
>  	{ .compatible = "nvidia,tegra124-pcie", .data = TEGRA124_PCIE },
> +	{ .compatible = "nvidia,tegra210-pcie", .data = TEGRA210_PCIE },
>  	{ }
>  };

and even with that fix, PCIe now doesn't work:

> Net:   RTL8169#0
> Warning: RTL8169#0 using MAC address from net device
>
> Hit any key to stop autoboot:  0
> Tegra210 (P2371-2180) # dhcp zImage
> pci_hose_bus_to_phys: invalid physical address
> pci_hose_bus_to_phys: invalid physical address
> pci_hose_bus_to_phys: invalid physical address
> pci_hose_bus_to_phys: invalid physical address
> pci_hose_bus_to_phys: invalid physical address
> pci_hose_bus_to_phys: invalid physical address
> BOOTP broadcast 1
> pci_hose_bus_to_phys: invalid physical address
> BOOTP broadcast 2
> pci_hose_bus_to_phys: invalid physical address
> BOOTP broadcast 3
> pci_hose_bus_to_phys: invalid physical address
...

Perhaps there's some obvious mistake somewhere you can find by code 
inspection. Otherwise, let me know if you need me to debug that.