[U-Boot] [PATCH 06/17] eeprom: Zap CONFIG_SPI_X

[Heiko Schocher <hs@denx.de>]

Hello Marek,

Am 10.11.2015 um 20:53 schrieb Marek Vasut:
> This macro is no longer used, so just reap it.
>
> Signed-off-by: Marek Vasut <marex@denx.de>
> Cc: Tom Rini <trini@konsulko.com>
> Cc: Simon Glass <sjg@chromium.org>
> Cc: Heiko Schocher <hs@denx.de>
> ---
>   README              | 5 -----
>   common/cmd_eeprom.c | 8 ++++----
>   2 files changed, 4 insertions(+), 9 deletions(-)


Reviewed-by: Heiko Schocher <hs@denx.de>

bye,
Heiko
>
> diff --git a/README b/README
> index ef8d437..8fb81e9 100644
> --- a/README
> +++ b/README
> @@ -2705,11 +2705,6 @@ CBFS (Coreboot Filesystem) support
>   		Enables the driver for SPI controller on SuperH. Currently
>   		only SH7757 is supported.
>
> -		CONFIG_SPI_X
> -
> -		Enables extended (16-bit) SPI EEPROM addressing.
> -		(symmetrical to CONFIG_I2C_X)
> -
>   		CONFIG_SOFT_SPI
>
>   		Enables a software (bit-bang) SPI driver rather than
> diff --git a/common/cmd_eeprom.c b/common/cmd_eeprom.c
> index ea1d447..728606e 100644
> --- a/common/cmd_eeprom.c
> +++ b/common/cmd_eeprom.c
> @@ -78,7 +78,7 @@ int eeprom_read (unsigned dev_addr, unsigned offset, uchar *buffer, unsigned cnt
>   		unsigned maxlen;
>   #endif
>
> -#if CONFIG_SYS_I2C_EEPROM_ADDR_LEN == 1 && !defined(CONFIG_SPI_X)
> +#if CONFIG_SYS_I2C_EEPROM_ADDR_LEN == 1
>   		uchar addr[2];
>
>   		blk_off = offset & 0xFF;	/* block offset */
> @@ -95,7 +95,7 @@ int eeprom_read (unsigned dev_addr, unsigned offset, uchar *buffer, unsigned cnt
>   		addr[1] = offset >>  8;		/* upper address octet */
>   		addr[2] = blk_off;		/* lower address octet */
>   		alen	= 3;
> -#endif	/* CONFIG_SYS_I2C_EEPROM_ADDR_LEN, CONFIG_SPI_X */
> +#endif	/* CONFIG_SYS_I2C_EEPROM_ADDR_LEN */
>
>   		addr[0] |= dev_addr;		/* insert device address */
>
> @@ -151,7 +151,7 @@ int eeprom_write (unsigned dev_addr, unsigned offset, uchar *buffer, unsigned cn
>   		unsigned maxlen;
>   #endif
>
> -#if CONFIG_SYS_I2C_EEPROM_ADDR_LEN == 1 && !defined(CONFIG_SPI_X)
> +#if CONFIG_SYS_I2C_EEPROM_ADDR_LEN == 1
>   		uchar addr[2];
>
>   		blk_off = offset & 0xFF;	/* block offset */
> @@ -168,7 +168,7 @@ int eeprom_write (unsigned dev_addr, unsigned offset, uchar *buffer, unsigned cn
>   		addr[1] = offset >>  8;		/* upper address octet */
>   		addr[2] = blk_off;		/* lower address octet */
>   		alen	= 3;
> -#endif	/* CONFIG_SYS_I2C_EEPROM_ADDR_LEN, CONFIG_SPI_X */
> +#endif	/* CONFIG_SYS_I2C_EEPROM_ADDR_LEN */
>
>   		addr[0] |= dev_addr;		/* insert device address */
>
>

-- 
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany