[U-Boot] Please pull u-boot-sunxi master

Hans de Goede
2015-01-14T14:16:44Z

Hi Tom,

We've been building a collection of very nice improvements for sunxi
while v2015.01 was stabilizing, please pull u-boot-sunxi/master into master,
highlights:

1) Improved sun6i (A31) support, including support for the A31s variant and
automatic assignment of a SoC serial based MAC address for ethernet
2) Full sun8i (A23) support including DRAM controller init and SPL, so now
people can boot these boards using a full FOSS solution
3) Many improvement to the graphical console support, automatic selection
of the native mode for HDMI/DVI monitors via DDC + EDID, LCD panel support,
VGA output support
4) Preparation work for OTG controller support, together with 3) this allows using
u-boot on tablets effortlessly. The rest of the OTG support is going upstream
through the usb tree

The following changes since commit 5f88ed5cde04612e5b4520327b82d81a3f5493a0:

Merge git://git.denx.de/u-boot-x86 (2015-01-13 13:39:25 -0500)

are available in the git repository at:

http://git.denx.de/u-boot-sunxi.git master

for you to fetch changes up to a90e77dbeb92f78ec06547621a7b22a785a43a3d:

sunxi: usbc: Add support for usb-vbus0 controller by axp drivebus pin (2015-01-14 14:56:40 +0100)

----------------------------------------------------------------
Axel Lin (1):
mmc: sunxi: Fix misuse of gpio_direction_input()

Chen-Yu Tsai (5):
sun6i: Add new board Merrii Hummingbird A31
sunxi: video: Allow external DACs for VGA on platforms without TV encoders
sunxi: video: Add support for external DAC enable pin
sunxi: Hummingbird_A31_defconfig: Enable VGA output through external DAC
sunxi: axp221: correct ALDO2 description for sun6i

Hans de Goede (66):
sun6i: Make dram clk and zq value Kconfig options
sun6i: Add sunxi_get_ss_bonding_id() function
sun6i: dram: Do not try to initialize a second dram chan on A31s
sun6i: Add new CSQ_CS908 board
sun6i: Update Colombus defconfig settings
sunxi: mmc: Properly setup mod-clk and clock sampling phases
sun6i: axp221: Add axp221_get_sid function
sunxi: Add sunxi_get_sid helper function
sun6i: s/SUNXI_*P2WI*/SUN6I_*P2WI*/
sunxi: Add support for the rsb (Reduced Serial Bus)
sunxi: axp221: Add axp223 support
sunxi: axp221: Add Kconfig help and sane defaults for typical ldo usage
sunxi: axp221: Make dcdc1 voltage configurable
sunxi: axp221: Explicitly turn off unused voltages
sunxi: axp221: Disable dcdc4 on sun8i (A23)
sun6i: Add a sigma_delta_enable paramter to clock_set_pll5()
sun6i: clock_set_pll5: Calculate k and m rather then hardcoding them
sunxi: Move await_completion dram helper to dram.h
sunxi: Fill memory before comparing it when doing dram init on sun6i
sunxi: Use memcmp for mctl_mem_matches
sun8i: Add dram initialization support
sun8i: Ippo_q8h_v5_defconfig: Enable SPL support
sun8i: Add defconfig for Ippo_q8h v1.2
sunxi: Fix PLL1 running at half speed on sun8i
sun7i: Add new Bananapro board / defconfig
videomodes: Add pixelclock_khz and refresh fields to ctfb_res_modes
videomodes: Add (vesa) standard timings
videomodes: Add a bunch of high res modes
videomodes: Add video_get_ctfb_res_modes helper function
videomodes: Add helper functions to parse video-mode env-var extra options
videomodes: Add video_edid_dtd_to_ctfb_res_modes helper function
edid: Add an edid_check_checksum() helper function
edid: Add struct and defines for cea681 extension blocks
sunxi: video: Use video-mode/-timing from videomodes
sunxi: video: Add support for video-mode environment variable
sunxi: video: Add hpd option
sunxi: video: Add DDC & EDID support
sunxi: video: Add hdmi support
sunxi: video: Add sunxi_hdmi_edid_get_block helper function
sunxi: video: When using edid use CEA681 extension blocks to select hdmi output
sunxi: video: Give hotplug-detect (hpd) signal some time to show up
sunxi: video: Set input sync enable
sunxi: gpio: Properly sort mux defines by port number
sunxi: gpio: Add support for gpio pins on the AXP209 pmic
sunxi: video: Improve monitor video-mode option handling
sunxi: video: Prepare for lcd support
sunxi: video: Modify sunxi_lcdc_pll_set to work with both tcon0 and tcon1
sunxi: video: Move sunxi_drc_init
sunxi: video: Add lcd output support
sunxi: video: Enable video on sun8i, which supports LCD but not HDMI
sunxi: video: Add support for VGA via external DACs connected to the LCD pins
sunxi: sunxi-common.h: Reduce bootm_size to take the framebuffer into account
sunxi: A13-OLinuXino defconfigs: Enable VGA output, add lcd-mode for 7" LCD
sunxi: Ippo_q8h defconfigs: Enable the LCD panel found on these tablets.
sunxi: video: Remove sunxi_display.enabled variable
sunxi: video: Use sunxi_lcdc_get_clk_delay to calculate tcon1 delay
sunxi: video: Add support for using PORTD hsync/vsync pins with tcon1
sunxi: video: Fallback from HDMI to VGA on boards with VGA
sunxi: video: Add VGA output support
sunxi: video: Add a hpd_delay parameter to configure hpd delay
sunxi: video: Add lvds support
sunxi: axp221: Protect axp221_init against multiple calls
sunxi: axp221: Add support for controlling the drivebus pin
sunxi: Move usb-controller init code out of ehci-sunxi.c for reuse for otg
sunxi: usbc: Add support for usb0 to the common usbc code
sunxi: usbc: Add support for usb-vbus0 controller by axp drivebus pin

Jan Kiszka (3):
sunxi: Align PSCI stack calculation to comment
sun7i: Add support for taking CPUs offline via PSCI
sun7i: Move psci_arch_init close to text_end

Siarhei Siamashka (6):
sunxi: Fix CONFIG_UART0_PORT_F build and add it to menuconfig
sun6i: Add defconfig for MSI Primo81 tablet
sun7i: Add defconfig for MSI Primo73 tablet
sunxi: Fix buggy sun6i/sun8i DRAM size detection logic
console: Use pre-console buffer to get complete log on all consoles
sunxi: Enable pre-console buffer

Zoltan HERPAI (1):
sunxi: add Linksprite pcDuino v1/v2 support

arch/arm/cpu/armv7/sunxi/Makefile | 5 +-
arch/arm/cpu/armv7/sunxi/board.c | 3 +-
arch/arm/cpu/armv7/sunxi/clock_sun6i.c | 26 +-
arch/arm/cpu/armv7/sunxi/cpu_info.c | 57 +-
arch/arm/cpu/armv7/sunxi/dram_sun4i.c | 17 +-
arch/arm/cpu/armv7/sunxi/dram_sun6i.c | 77 +--
arch/arm/cpu/armv7/sunxi/dram_sun8i.c | 345 +++++++++++
arch/arm/cpu/armv7/sunxi/p2wi.c | 14 +-
arch/arm/cpu/armv7/sunxi/psci.S | 201 ++++++-
arch/arm/cpu/armv7/sunxi/rsb.c | 158 +++++
arch/arm/cpu/armv7/sunxi/usbc.c | 272 +++++++++
arch/arm/include/asm/arch-sunxi/clock.h | 1 -
arch/arm/include/asm/arch-sunxi/clock_sun4i.h | 23 +-
arch/arm/include/asm/arch-sunxi/clock_sun6i.h | 31 +-
arch/arm/include/asm/arch-sunxi/cpu.h | 13 +-
arch/arm/include/asm/arch-sunxi/display.h | 219 ++++++-
arch/arm/include/asm/arch-sunxi/dram.h | 29 +
arch/arm/include/asm/arch-sunxi/dram_sun8i.h | 266 +++++++++
arch/arm/include/asm/arch-sunxi/gpio.h | 22 +-
arch/arm/include/asm/arch-sunxi/prcm.h | 3 +-
arch/arm/include/asm/arch-sunxi/rsb.h | 55 ++
arch/arm/include/asm/arch-sunxi/usbc.h | 20 +
board/sunxi/Kconfig | 176 +++++-
board/sunxi/MAINTAINERS | 27 +-
board/sunxi/Makefile | 3 +
board/sunxi/board.c | 48 +-
board/sunxi/dram_sun4i_408_1024_iow8.c | 31 +
board/sunxi/gmac.c | 2 +-
common/console.c | 46 +-
common/edid.c | 12 +
configs/A13-OLinuXinoM_defconfig | 9 +-
configs/A13-OLinuXino_defconfig | 9 +-
configs/A20-OLinuXino_MICRO_defconfig | 1 +
configs/Bananapro_defconfig | 9 +
configs/CSQ_CS908_defconfig | 16 +
configs/Colombus_defconfig | 8 +-
configs/Cubietruck_defconfig | 1 +
configs/Hummingbird_A31_defconfig | 17 +
configs/Ippo_q8h_v1_2_defconfig | 18 +
configs/Ippo_q8h_v5_defconfig | 23 +-
configs/Linksprite_pcDuino_defconfig | 7 +
configs/MSI_Primo73_defconfig | 12 +
configs/MSI_Primo81_defconfig | 12 +
configs/Mele_A1000G_defconfig | 1 +
configs/Mele_A1000_defconfig | 1 +
configs/Mele_M3_defconfig | 1 +
configs/Mele_M9_defconfig | 7 +-
doc/README.video | 55 +-
drivers/gpio/sunxi_gpio.c | 32 +-
drivers/mmc/sunxi_mmc.c | 102 +++-
drivers/power/Kconfig | 54 +-
drivers/power/axp209.c | 72 +++
drivers/power/axp221.c | 245 +++++++-
drivers/usb/host/ehci-sunxi.c | 213 +------
drivers/video/Makefile | 2 +-
drivers/video/sunxi_display.c | 825 ++++++++++++++++++++++----
drivers/video/videomodes.c | 201 ++++++-
drivers/video/videomodes.h | 22 +-
include/axp209.h | 7 +
include/axp221.h | 27 +-
include/configs/sun8i.h | 7 +
include/configs/sunxi-common.h | 22 +-
include/edid.h | 32 +
scripts/multiconfig.sh | 2 +-
64 files changed, 3698 insertions(+), 576 deletions(-)
create mode 100644 arch/arm/cpu/armv7/sunxi/dram_sun8i.c
create mode 100644 arch/arm/cpu/armv7/sunxi/rsb.c
create mode 100644 arch/arm/cpu/armv7/sunxi/usbc.c
create mode 100644 arch/arm/include/asm/arch-sunxi/dram_sun8i.h
create mode 100644 arch/arm/include/asm/arch-sunxi/rsb.h
create mode 100644 arch/arm/include/asm/arch-sunxi/usbc.h
create mode 100644 board/sunxi/dram_sun4i_408_1024_iow8.c
create mode 100644 configs/Bananapro_defconfig
create mode 100644 configs/CSQ_CS908_defconfig
create mode 100644 configs/Hummingbird_A31_defconfig
create mode 100644 configs/Ippo_q8h_v1_2_defconfig
create mode 100644 configs/Linksprite_pcDuino_defconfig
create mode 100644 configs/MSI_Primo73_defconfig
create mode 100644 configs/MSI_Primo81_defconfig

Regards,

Hans