[U-Boot] [PATCH] arm: socfpga: arria10: add additional i2c nodes for Arria10

Stefan Roese
2015-12-01T17:12:32Z

On 01.12.2015 17:41, dinguyen at opensource.altera.com wrote:
> From: Dinh Nguyen <dinguyen@opensource.altera.com>
>
> Add remaining 3 I2C base addresses for the Arria10.
>
> Signed-off-by: Dinh Nguyen <dinguyen@opensource.altera.com>
> ---
> arch/arm/mach-socfpga/include/mach/base_addr_a10.h | 4 ++++
> 1 file changed, 4 insertions(+)
>
> diff --git a/arch/arm/mach-socfpga/include/mach/base_addr_a10.h b/arch/arm/mach-socfpga/include/mach/base_addr_a10.h
> index a7056d4..8653dd5 100644
> --- a/arch/arm/mach-socfpga/include/mach/base_addr_a10.h
> +++ b/arch/arm/mach-socfpga/include/mach/base_addr_a10.h
> @@ -29,6 +29,10 @@
> #define SOCFPGA_MPUL2_ADDRESS 0xfffff000
> #define SOCFPGA_I2C0_ADDRESS 0xffc02200
> #define SOCFPGA_I2C1_ADDRESS 0xffc02300
> +#define SOCFPGA_I2C2_ADDRESS 0xffc02400
> +#define SOCFPGA_I2C3_ADDRESS 0xffc02500
> +#define SOCFPGA_I2C4_ADDRESS 0xffc02600
> +
>
> #define SOCFPGA_ECC_OCRAM_ADDRESS 0xff8c3000
> #define SOCFPGA_UART0_ADDRESS 0xffc02000

Nitpicking, but there seems to be one empty line too much
added above.

Other than this:

Reviewed-by: Stefan Roese <sr@denx.de>

BTW: Is anyone working on DM conversion of this I2C driver? All
those macros for the base addresses would not be needed then.

Thanks,
Stefan