[U-Boot] [PATCH 7/7] arm: socfpga: socrates: Probe DWC2 UDC from OF instead of hard-coded data

[Dinh Nguyen <dinguyen@opensource.altera.com>]

On 12/05/2015 02:43 PM, Marek Vasut wrote:
> This patch adds the necessary OF alias for the UDC node, which let's
> the code locate the DWC2 UDC base address in OF instead of hard-coding
> it into the U-Boot binary. The code is adjusted to use the address from
> OF instead of the hard-coded one. Finally, the hard-coded address is
> removed and USB DM support is enabled.
> 
> Signed-off-by: Marek Vasut <marex@denx.de>
> Cc: Chin Liang See <clsee@altera.com>
> Cc: Dinh Nguyen <dinguyen@opensource.altera.com>
> Cc: Lukasz Majewski <l.majewski@majess.pl>
> Cc: Lukasz Majewski <l.majewski@samsung.com>
> ---
>  arch/arm/dts/socfpga_cyclone5_socrates.dts |  8 ++++++++
>  board/ebv/socrates/socfpga.c               | 21 +++++++++++++++++++--
>  configs/socfpga_socrates_defconfig         |  2 ++
>  include/configs/socfpga_socrates.h         |  3 ---
>  4 files changed, 29 insertions(+), 5 deletions(-)  

<snip>

> diff --git a/include/configs/socfpga_socrates.h b/include/configs/socfpga_socrates.h
> index de8ced6..1b0888f 100644
> --- a/include/configs/socfpga_socrates.h
> +++ b/include/configs/socfpga_socrates.h
> @@ -52,9 +52,6 @@
>  #define CONFIG_ENV_OFFSET		512	/* just after the MBR */
>  
>  /* USB */
> -#ifdef CONFIG_CMD_USB
> -#define CONFIG_USB_DWC2_REG_ADDR	SOCFPGA_USB1_ADDRESS
> -#endif
>  #define CONFIG_G_DNL_MANUFACTURER      "EBV"
>  
>  /* Extra Environment */
> 

With this patch series, I think you should follow up with a patch like
below?

---

diff --git a/include/configs/socfpga_common.h
b/include/configs/socfpga_common.h
index f74c758..b57fd4c 100644
--- a/include/configs/socfpga_common.h
+++ b/include/configs/socfpga_common.h
@@ -233,13 +233,6 @@ unsigned int cm_get_qspi_controller_clk_hz(void);
 #ifdef CONFIG_CMD_USB
 #define CONFIG_USB_DWC2
 #define CONFIG_USB_STORAGE
-/*
- * NOTE: User must define either of the following to select which
- *       of the two USB controllers available on SoCFPGA to use.
- *       The DWC2 driver doesn't support multiple USB controllers.
- * #define CONFIG_USB_DWC2_REG_ADDR    SOCFPGA_USB0_ADDRESS
- * #define CONFIG_USB_DWC2_REG_ADDR    SOCFPGA_USB1_ADDRESS
- */
 #endif

 /*


Dinh