[U-Boot] [GIT PULL] Microblaze changes

[Michal Simek <monstr@monstr.eu>]

Hi Tom,

here are microblaze patches for moving stuff to DM. This is the patch
series which we postpone to next release. Buildman doesn't show any
problems for mb, zynq_zc702 and zynqmp.

Thanks,
Michal

The following changes since commit d29892ba854f40980b84f86566cd0c2308c66afe:

  part_dos.c: Don't wrap to negative after 2G sectors (2016-01-13
16:33:20 -0500)

are available in the git repository at:

  git://www.denx.de/git/u-boot-microblaze.git mb

for you to fetch changes up to 8283903d4df0685af98a45d323f880ce07c60cec:

  microblaze: Fix board_init calling sequence (2016-01-14 09:35:04 +0100)

----------------------------------------------------------------
Michal Simek (45):
      microblaze: Remove CONSOLE_ARG
      microblaze: Move baudrate setting out driver selection
      serial: uartlite: Move driver to DM
      serial: uartlite: Add support for debug console
      serial: uartlite: Add uartlite to Kconfig
      microblaze: Enable uart16550 DM by default
      microblaze: Do not print eth device when DM_ETH is enabled
      microblaze: Enable PHYLIB via Kconfig
      microblaze: Remove unused I2C macros
      microblaze: Wire-up debug_uart in asm
      microblaze: Enable MICREL_KSZ9021
      net: axi_emac: Fix parentheses around operand !
      net: axi_emac: Show phy address instead of register content
      net: axi_emac: Pass directly pointer to register space
      net: axi_emac: Put iobase to private structure
      net: axi_emac: Pass private structure to phyread/phywrite
      net: axi_emac: Pass private structure where possible
      net: axi_emac: Move driver to DM
      net: axi_emac: Enable access to MDIO in probe
      net: axi_emac: Split recv from free_pkt
      net: axi_emac: Rename start, stop, write_hwaddr functions
      net: Add axi emac to Kconfig
      net: emaclite: Remove ancient OF probe function
      net: emaclite: Add MDIO support to driver
      net: emaclite: Convert MDIO to use register offset
      net: emaclite: Use indirect register access for tx_ping/pong
      net: emaclite: Use indirect register access for rx_ping/pong
      net: emaclite: Use indirect register access for TX reset
      net: emaclite: Fix logic around available TX buffers
      net: emaclite: Remove XEL_TSR_XMIT_ACTIVE_MASK flag
      net: emaclite: Use indirect reg access in send
      net: emaclite: Use indirect access in emaclite_recv
      net: emaclite: Move driver to DM
      net: emaclite: Rename start and stop functions
      net: emaclite: Let core to handle received packet
      net: emaclite: Move emaclite to Kconfig
      microblaze: Enable axi emac via Kconfig
      microblaze: Move eth configuration to Kconfig
      microblaze: Remove systemace from board file
      microblaze: Remove CONFIG_FIT from board file
      microblaze: Move CONFIG_NETCONSOLE to Kconfig
      microblaze: Remove empty file - cpu.c
      microblaze: Read information about RAM from DT
      microblaze: Enable HUSH via Kconfig
      microblaze: Fix board_init calling sequence

 arch/microblaze/Kconfig                              |   1 +
 arch/microblaze/cpu/Makefile                         |   2 +-
 arch/microblaze/cpu/cpu.c                            |   9 --
 arch/microblaze/cpu/start.S                          |   4 +
 board/xilinx/microblaze-generic/microblaze-generic.c |  39 +------
 board/xilinx/microblaze-generic/xparameters.h        |  21 ----
 board/xilinx/zynq/board.c                            |  24 ----
 common/cmd_bdinfo.c                                  |   2 +-
 configs/microblaze-generic_defconfig                 |  14 +++
 doc/device-tree-bindings/serial/xilinx_uartlite.txt  |  13 +++
 doc/driver-model/serial-howto.txt                    |   1 -
 drivers/net/Kconfig                                  |  16 +++
 drivers/net/xilinx_axi_emac.c                        | 280
++++++++++++++++++++++++++++-----------------
 drivers/net/xilinx_emaclite.c                        | 610
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++------------------------------
 drivers/serial/Kconfig                               |  14 +++
 drivers/serial/serial_xuartlite.c                    | 194
++++++++++++++-----------------
 include/configs/microblaze-generic.h                 |  74 +-----------
 include/netdev.h                                     |   5 -
 18 files changed, 757 insertions(+), 566 deletions(-)
 delete mode 100644 arch/microblaze/cpu/cpu.c
 create mode 100644 doc/device-tree-bindings/serial/xilinx_uartlite.txt


-- 
Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel - Microblaze cpu - http://www.monstr.eu/fdt/
Maintainer of Linux kernel - Xilinx Zynq ARM architecture
Microblaze U-BOOT custodian and responsible for u-boot arm zynq platform


-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 181 bytes
Desc: OpenPGP digital signature
URL: <http://lists.denx.de/pipermail/u-boot/attachments/20160114/dc53bc4f/attachment.sig>