[U-Boot] [PATCH v3] net: macb: Not all the GEM are gigabit capable

["Andreas Bießmann" <andreas.devel@googlemail.com>]

On 16.12.15 14:50, Gregory CLEMENT wrote:
> During the initialization of PHY the gigabit bit capable is set if the
> controller is a GEM. However, for sama5d2 and sama5d4, the GEM is
> configured to support only 10/100.
> 
> Improperly setting the GBE capability leads to an unresponsive MAC
> controller. This patch fixes this behavior allowing using the gmac with
> these SoCs.
> 
> Suggested-by: Nicolas Ferre <nicolas.ferre@atmel.com>
> Signed-off-by: Gregory CLEMENT <gregory.clement@free-electrons.com>

Reviewed-by: Andreas Bie?mann <andreas.devel@googlemail.com>

> ---
> Hi,
> 
> in this v3, I fixed the sama5d2 typo and the missing brace.
> 
> I also took care of the cpu_is_* symbols which may not be defined
> depending of the choice of the SoC.
> 
> Gregory
> 
> drivers/net/macb.c | 21 +++++++++++++++++++--
>  1 file changed, 19 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/net/macb.c b/drivers/net/macb.c
> index a5c1880..e801313 100644
> --- a/drivers/net/macb.c
> +++ b/drivers/net/macb.c
> @@ -109,6 +109,23 @@ static int macb_is_gem(struct macb_device *macb)
>  	return MACB_BFEXT(IDNUM, macb_readl(macb, MID)) == 0x2;
>  }
>  
> +#ifndef cpu_is_sama5d2
> +#define cpu_is_sama5d2() 0
> +#endif
> +
> +#ifndef cpu_is_sama5d4
> +#define cpu_is_sama5d4() 0
> +#endif
> +
> +static int gem_is_gigabit_capable(struct macb_device *macb)
> +{
> +	/*
> +	 * The GEM controllers embeded in SAMA5D2 and SAMA5D4 are
> +	 * configured to support only 10/100.
> +	 */
> +	return macb_is_gem(macb) && !cpu_is_sama5d2() && !cpu_is_sama5d4();
> +}
> +
>  static void macb_mdio_write(struct macb_device *macb, u8 reg, u16 value)
>  {
>  	unsigned long netctl;
> @@ -480,8 +497,8 @@ static int macb_phy_init(struct macb_device *macb)
>  		return 0;
>  	}
>  
> -	/* First check for GMAC */
> -	if (macb_is_gem(macb)) {
> +	/* First check for GMAC and that it is GiB capable */
> +	if (gem_is_gigabit_capable(macb)){
>  		lpa = macb_mdio_read(macb, MII_STAT1000);
>  
>  		if (lpa & (LPA_1000FULL | LPA_1000HALF)) {
>