From mboxrd@z Thu Jan 1 00:00:00 1970 From: Olliver Schinagl Date: Tue, 26 Jan 2016 17:11:52 +0100 Subject: [U-Boot] [PATCH v2 3/5] sunxi: net: Enable eeprom on OLinuXino Lime2 boards In-Reply-To: References: <1450096872-16733-1-git-send-email-o.schinagl@ultimaker.com> <1450096872-16733-4-git-send-email-o.schinagl@ultimaker.com> Message-ID: <56A79AC8.4030700@ultimaker.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hey Joe, On 26-01-16 01:34, Joe Hershberger wrote: > Hi Olliver, > > On Mon, Dec 14, 2015 at 6:41 AM, Olliver Schinagl > wrote: >> This patch enables the I2C EEPROM to be probed for a MAC address on the >> OLinuXino board. >> >> Signed-off-by: Olliver Schinagl >> --- > You should use patman so that you can keep track of changes in > revisions of your patches. I just looked up on it and it looks like a good tool! So I will try to get familiar with it, thanks for the tip! > >> configs/A20-OLinuXino-Lime2_defconfig | 3 +++ >> 1 file changed, 3 insertions(+) >> >> diff --git a/configs/A20-OLinuXino-Lime2_defconfig b/configs/A20-OLinuXino-Lime2_defconfig >> index b5181c6..5e38618 100644 >> --- a/configs/A20-OLinuXino-Lime2_defconfig >> +++ b/configs/A20-OLinuXino-Lime2_defconfig >> @@ -14,4 +14,7 @@ CONFIG_SYS_EXTRA_OPTIONS="SUNXI_GMAC,RGMII,AHCI,SATAPWR=SUNXI_GPC(3)" >> # CONFIG_CMD_FPGA is not set >> CONFIG_CMD_GPIO=y >> CONFIG_ETH_DESIGNWARE=y >> +CONFIG_NET_ETHADDR_EEPROM=y >> +CONFIG_NET_ETHADDR_EEPROM_I2C=y >> +CONFIG_NET_ETHADDR_EEPROM_I2C_BUS=1 >> CONFIG_USB_EHCI_HCD=y >> -- >> 2.6.2 >> >> _______________________________________________ >> U-Boot mailing list >> U-Boot at lists.denx.de >> http://lists.denx.de/mailman/listinfo/u-boot -- Met vriendelijke groeten, Kind regards, ?????? Olliver Schinagl Software Engineer Research & Development Ultimaker B.V.