From mboxrd@z Thu Jan 1 00:00:00 1970 From: Marek Vasut Date: Mon, 29 Feb 2016 13:04:11 +0100 Subject: [U-Boot] [PATCH 05/17] drivers: usb: musb: adopt musb backend driver to driver model In-Reply-To: <1456717460-3132-6-git-send-email-mugunthanvnm@ti.com> References: <1456717460-3132-1-git-send-email-mugunthanvnm@ti.com> <1456717460-3132-6-git-send-email-mugunthanvnm@ti.com> Message-ID: <56D433BB.7000101@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 02/29/2016 04:44 AM, Mugunthan V N wrote: > Currently all backend driver ops uses hard coded physical > address, so to adopt the driver to DM, add device pointer to ops > call backs so that drivers that drivers can get physical > addresses from the usb driver priv/plat data. > > Signed-off-by: Mugunthan V N > --- [...] > @@ -704,8 +719,13 @@ static int dsps_resume(struct device *dev) > struct omap_musb_board_data *data = plat->board_data; > > /* Start the on-chip PHY and its PLL. */ > +#ifndef CONFIG_DM_USB > if (data->set_phy_power) > data->set_phy_power(1); > +#else > + if (data->set_phy_power) > + data->set_phy_power(data->dev, 1); Would it be possible to avoid adding this sea of ifdefs into the driver? > +#endif > > return 0; > } > -- Best regards, Marek Vasut