[U-Boot] [PATCH v2] arm: imx: Add support for GE Bx50v3 boards

[Akshay Bhat <akshay.bhat@timesys.com>]

Hi Stefano,

On 01/29/2016 11:07 PM, Peng Fan wrote:
> Hi Akshay,
>
> On Fri, Jan 29, 2016 at 03:16:40PM -0500, Akshay Bhat wrote:
>> Add support for GE B450v3, B650v3 and B850v3 boards. The boards
>> are based on Advantech BA16 module which has a i.MX6D processor.
>> The boards support:
>> - FEC Ethernet
>> - USB Ports
>> - SDHC and MMC boot
>> - SPI NOR
>> - LVDS and HDMI display
>>
>> Basic information about the module:
>> - Module manufacturer: Advantech
>> - CPU: Freescale ARM Cortex-A9 i.MX6D
>> - SPECS:
>>      Up to 2GB Onboard DDR3 Memory;
>>      Up to 16GB Onboard eMMC NAND Flash
>>      Supports OpenGL ES 2.0 and OpenVG 1.1
>>      HDMI, 24-bit LVDS
>>      1x UART, 2x I2C, 8x GPIO,
>>      4x Host USB 2.0 port, 1x USB OTG port,
>>      1x micro SD (SDHC),1x SDIO, 1x SATA II,
>>      1x 10/100/1000 Mbps Ethernet, 1x PCIe X1 Gen2
>>
>> Signed-off-by: Akshay Bhat <akshay.bhat@timesys.com>
>
>
> Reviewed-by: Peng Fan <peng.fan@nxp.com>
>
> Regards,
> Peng.
>

If there are no further review comments, can this patch be applied in 
the next merge window (for v2016.05)?

Also I have couple updates to the bx50v3.c file. Should I wait for this 
patch to be applied before sending a new patch with the changes (wasn't 
sure if you had a -next branch where the v2 patch was already applied)?

Thanks,
Akshay