[U-Boot] [PATCH v2] arm: imx: Add support for GE Bx50v3 boards

[Stefano Babic <sbabic@denx.de>]

Hi Akshay,

On 08/03/2016 23:48, Akshay Bhat wrote:
> Hi Stefano,
> 
> On 01/29/2016 11:07 PM, Peng Fan wrote:
>> Hi Akshay,
>>
>> On Fri, Jan 29, 2016 at 03:16:40PM -0500, Akshay Bhat wrote:
>>> Add support for GE B450v3, B650v3 and B850v3 boards. The boards
>>> are based on Advantech BA16 module which has a i.MX6D processor.
>>> The boards support:
>>> - FEC Ethernet
>>> - USB Ports
>>> - SDHC and MMC boot
>>> - SPI NOR
>>> - LVDS and HDMI display
>>>
>>> Basic information about the module:
>>> - Module manufacturer: Advantech
>>> - CPU: Freescale ARM Cortex-A9 i.MX6D
>>> - SPECS:
>>>      Up to 2GB Onboard DDR3 Memory;
>>>      Up to 16GB Onboard eMMC NAND Flash
>>>      Supports OpenGL ES 2.0 and OpenVG 1.1
>>>      HDMI, 24-bit LVDS
>>>      1x UART, 2x I2C, 8x GPIO,
>>>      4x Host USB 2.0 port, 1x USB OTG port,
>>>      1x micro SD (SDHC),1x SDIO, 1x SATA II,
>>>      1x 10/100/1000 Mbps Ethernet, 1x PCIe X1 Gen2
>>>
>>> Signed-off-by: Akshay Bhat <akshay.bhat@timesys.com>
>>
>>
>> Reviewed-by: Peng Fan <peng.fan@nxp.com>
>>
>> Regards,
>> Peng.
>>
> 
> If there are no further review comments, can this patch be applied in
> the next merge window (for v2016.05)?
> 

Yes, I will do it.

> Also I have couple updates to the bx50v3.c file. Should I wait for this
> patch to be applied before sending a new patch with the changes (wasn't
> sure if you had a -next branch where the v2 patch was already applied)?
> 

Tom has proposed several times to the custodian to have a -next branch,
and making it really working. I admit I have not done enough for that,
and it is something I can improve. I will prepare a "working" -next, to
be merged into master after release.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================