From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefan Roese Date: Wed, 6 Apr 2016 16:46:26 +0200 Subject: [U-Boot] Fwd: Marvell Armada XP u-boot from uart In-Reply-To: <1459938056743-251080.post@n7.nabble.com> References: <5560357C.5010902@denx.de> <1459938056743-251080.post@n7.nabble.com> Message-ID: <57052142.9060305@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 06.04.2016 12:20, pani wrote: > I have a Armada A388 board that I have the same problem with. > (Using u-boot git master branch from today) > > After downloading the kwb-file, the output is as below. > This is the same with the BOOT_FROM untouched or set to uart. > > Did you have any luck finding out what the problem was? > > Sending boot message. Please reboot the target...- > Sending boot image... > 0 % > [......................................................................] > 1 % > [......................................................................] > 3 % > [......................................................................] > 5 % > [......................................................................] > 6 % > [......................................................................] > 8 % > [......................................................................] > 10 % > [......................................................................] > 12 % > [......................................................................] > 13 % > [......................................................................] > 15 % > [......................................................................] > 17 % > [......................................................................] > 18 % > [......................................................................] > 20 % > [......................................................................] > 22 % > [......................................................................] > 24 % > [......................................................................] > 25 % > [......................................................................] > 27 % > [......................................................................] > 29 % > [......................................................................] > 30 % [................... > U-Boot SPL 2016.03-00668-g4ed6ed3-dirty (Apr 06 2016 - 11:00:55) > High speed PHY - Version: 2.0 > Detected Device ID 6828 > board SerDes lanes topology details: > | Lane # | Speed | Type | > -------------------------------- > | 0 | 3 | SATA0 | > | 1 | 0 | SGMII1 | > | 2 | 5 | PCIe1 | > | 3 | 5 | USB3 HOST1 | > | 4 | 5 | PCIe2 | > | 5 | 0 | SGMII2 | > -------------------------------- > PCIe, Idx 1: detected no link > PCIe, Idx 2: detected no link > High speed PHY - Ended Successfully > DDR3 Training Sequence - Ver TIP-1.29.0 > DDR3 Training Sequence - Switching XBAR Window to FastPath Window > DDR3 Training Sequence - Ended Successfully > Trying to boot from unknown boot device > SPL: Unsupported Boot Device! > SPL: failed to boot from all boot devices > ### ERROR ### Please RESET the board ### > +xmodem: Protocol error Which board is this? Is it a custom Armada 38x board? Or an already in mainline U-Boot supported board? The message above is pretty clear: > SPL: Unsupported Boot Device! What is the boot device that you are using? And how are you initiating the UART boot? Via a software reset (JTAG)? Or via a power-on reset? Note: In general the UART boot does work pretty good. I've not had problems with it in the last months (AFAIR). Thanks, Stefan