[U-Boot] [PATCH 2/3] usb: s3c-otg: Fix short packet for request size > ep.maxpacket

[Roger Quadros <rogerq@ti.com>]

Hi Lukasz,

On 19/04/16 12:02, Lukasz Majewski wrote:
> Hi Roger,
> 
>> Request size can be greater than ep.packet and still end in a
>> short packet. We need to tackle this case as end of transfer
>> (if short_not_ok is not set) as indicated in USB 2.0 Specification
>> [1], else we get stuck up on certain protocols like fastboot.
>>
>> [1] - USB2.0 Specification, Section 5.3.2 Pipes
>>
>> Reported-by: Steve Rae <steve.rae@broadcom.com>
>> Signed-off-by: Roger Quadros <rogerq@ti.com>
>> Tested-by: Steve Rae <steve.rae@broadcom.com>
>> ---
>>  drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c | 2 +-
>>  1 file changed, 1 insertion(+), 1 deletion(-)
>>
>> diff --git a/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c
>> b/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c index bce9c30..a31d875
>> 100644 --- a/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c
>> +++ b/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c
>> @@ -229,7 +229,7 @@ static void complete_rx(struct dwc2_udc *dev, u8
>> ep_num) ROUND(xfer_size, CONFIG_SYS_CACHELINE_SIZE));
>>  
>>  	req->req.actual += min(xfer_size, req->req.length -
>> req->req.actual);
>> -	is_short = (xfer_size < ep->ep.maxpacket);
>> +	is_short = xfer_size % ep->ep.maxpacket;
> 
> is_short is a flag - so maybe it would be better to write something
> like:

but it is defined as u32 so I thought it might as well print the
short packet length instead of just 1/0.

> 
> is_short = !!(xfer_size % ep->ep.maxpacket)) ?
> 
> I'm going to test those patches on my boards. I will share the results
> ASAP.
> 
>>  
>>  	debug_cond(DEBUG_OUT_EP != 0,
>>  		   "%s: RX DMA done : ep = %d, rx bytes = %d/%d, "
> 
> 
> 

--
cheers,
-roger