[U-Boot] [PATCH 2/3] usb: s3c-otg: Fix short packet for request size > ep.maxpacket

[Roger Quadros <rogerq@ti.com>]

On 19/04/16 14:25, Lukasz Majewski wrote:
> Hi Roger,
> 
>> Hi Lukasz,
>>
>> On 19/04/16 12:02, Lukasz Majewski wrote:
>>> Hi Roger,
>>>
>>>> Request size can be greater than ep.packet and still end in a
>>>> short packet. We need to tackle this case as end of transfer
>>>> (if short_not_ok is not set) as indicated in USB 2.0 Specification
>>>> [1], else we get stuck up on certain protocols like fastboot.
>>>>
>>>> [1] - USB2.0 Specification, Section 5.3.2 Pipes
>>>>
>>>> Reported-by: Steve Rae <steve.rae@broadcom.com>
>>>> Signed-off-by: Roger Quadros <rogerq@ti.com>
>>>> Tested-by: Steve Rae <steve.rae@broadcom.com>
>>>> ---
>>>>  drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c | 2 +-
>>>>  1 file changed, 1 insertion(+), 1 deletion(-)
>>>>
>>>> diff --git a/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c
>>>> b/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c index bce9c30..a31d875
>>>> 100644 --- a/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c
>>>> +++ b/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c
>>>> @@ -229,7 +229,7 @@ static void complete_rx(struct dwc2_udc *dev,
>>>> u8 ep_num) ROUND(xfer_size, CONFIG_SYS_CACHELINE_SIZE));
>>>>  
>>>>  	req->req.actual += min(xfer_size, req->req.length -
>>>> req->req.actual);
>>>> -	is_short = (xfer_size < ep->ep.maxpacket);
>>>> +	is_short = xfer_size % ep->ep.maxpacket;
>>>
>>> is_short is a flag - so maybe it would be better to write something
>>> like:
>>
>> but it is defined as u32 so I thought it might as well print the
>> short packet length instead of just 1/0.
> 
> I mean that it looks strange for me in debug message when one see:
> 
> "is_short: 8" (as it was shown at Steve's output).

Agreed. I'll convert it to boolean then.

--
cheers,
-roger