[U-Boot] [PATCH v2 2/3] usb: s3c-otg: Fix short packet for request size > ep.maxpacket

[Roger Quadros <rogerq@ti.com>]

Request size can be greater than ep.packet and still end in a
short packet. We need to tackle this case as end of transfer
(if short_not_ok is not set) as indicated in USB 2.0 Specification [1],
else we get stuck up on certain protocols like fastboot.

[1] - USB2.0 Specification, Section 5.3.2 Pipes

Reported-by: Steve Rae <steve.rae@broadcom.com>
Signed-off-by: Roger Quadros <rogerq@ti.com>
Tested-by: Steve Rae <steve.rae@broadcom.com>
---
 drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c b/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c
index bce9c30..9aa0f33 100644
--- a/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c
+++ b/drivers/usb/gadget/dwc2_udc_otg_xfer_dma.c
@@ -229,7 +229,7 @@ static void complete_rx(struct dwc2_udc *dev, u8 ep_num)
 				ROUND(xfer_size, CONFIG_SYS_CACHELINE_SIZE));
 
 	req->req.actual += min(xfer_size, req->req.length - req->req.actual);
-	is_short = (xfer_size < ep->ep.maxpacket);
+	is_short = !!(xfer_size % ep->ep.maxpacket);
 
 	debug_cond(DEBUG_OUT_EP != 0,
 		   "%s: RX DMA done : ep = %d, rx bytes = %d/%d, "
-- 
2.5.0