From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Sat, 18 Jun 2016 10:31:29 +0200 Subject: [U-Boot] [PATCH 1/4] mx7dsabresd: Fix LCD_PWR_EN output setting In-Reply-To: <1465971519-22344-1-git-send-email-peng.fan@nxp.com> References: <1465971519-22344-1-git-send-email-peng.fan@nxp.com> Message-ID: <576506E1.8050005@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 15/06/2016 08:18, Peng Fan wrote: > From: Ye Li > > LCD_PWR_EN controls the G pin of Q13 PMOS which needs low voltage to connect > D to S for outputting LCD 3.3V. If LCD_PWR_EN is high, we measured the LCD 3v3 > is actually 1.2V. > > Signed-off-by: Ye Li > Signed-off-by: Peng Fan > Cc: Stefano Babic > Cc: Fabio Estevam > --- > board/freescale/mx7dsabresd/mx7dsabresd.c | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/board/freescale/mx7dsabresd/mx7dsabresd.c b/board/freescale/mx7dsabresd/mx7dsabresd.c > index c3062f1..1f4fc03 100644 > --- a/board/freescale/mx7dsabresd/mx7dsabresd.c > +++ b/board/freescale/mx7dsabresd/mx7dsabresd.c > @@ -171,7 +171,7 @@ static enum qn_level seq[3][2] = { > > static enum qn_func qn_output[8] = { > qn_disable, qn_reset, qn_reset, qn_reset, qn_reset, qn_reset, qn_enable, > - qn_enable > + qn_disable > }; > > static void iox74lv_init(void) > Applied to master (bug fix), thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================