[U-Boot] [PATCH v3 0/5] add support for rk3399 soc and evb

[Kever Yang <kever.yang@rock-chips.com>]

Hi Heiko,

On 07/16/2016 06:15 AM, Heiko St?bner wrote:
> Hi Kever,
>
> Am Freitag, 15. Juli 2016, 16:42:08 schrieb Kever Yang:
>> This patchset add support for rk3399 with ATF based on
>> Rockchip miniloader as secondary bootloader instead of
>> u-boot SPL.
>>
>> Rockchip miniloader init the DRAM and load the ATF and
>> u-boot to runing address, and then jump to ATF, ATM
>> do some init and switch to EL2/EL1 mode before jump to
>> next loader which is u-boot here.
>>
>> Pls reference board/rockchip/evb_rk3399/README to setup
>> the board.
>>
>> Will migrate to SPL once its ready for ATF.
>>
>> This patch set is based on below patch:
>> "board: move all the rockchip board in one folder"
>>
>> This patch set has been test on rk3399 evb board.
> just for my own little board-farm, for the rk3368 the bringup should be
> similar, right?
Yes, similar for uboot part, both ARM v8 cpu, but they have different 
DDR/MMC controller.
Andreas has send out patch to support rk3368.
>
>
>> Changes in v3:
>> Rebase on patch from Andreas:
>> [PATCH] rockchip: Exclude rk_timer for ARM64
>> [PATCH] rockchip: Clean up CPU selection
>>
>> Changes in v2:
>> fix description error on board Kconfig
>> fix a binary path error
>>
>> Kever Yang (5):
>>    dts: add support for rkchichip rk3399 soc
>>    ARM64: rockchip: add support for rk3399 SoC based evb-board
>>    config: add config file for evb-rk3399
>>    mmc: rockchip: add SDHCI driver support for rockchip soc
>>    ARM64: evb-rk3399: add a README for this board setup
> somehow this last patch never makes it to the lists in all 3 versions till
> now.
I don't now why, I will send it with git send-email again.

Thanks,
- Kever
>
>
> Heiko
>
>
>