[U-Boot] [PATCH 3/4] Armada100: Enable 88E3015 PHY support for GplugD

[Ajay Bhargav <ajay.bhargav@einfochips.com>]

----- "Prafulla Wadaskar" <prafulla@marvell.com> wrote:

> > -----Original Message-----
> > From: Ajay Bhargav [mailto:ajay.bhargav at einfochips.com]
> > Sent: Monday, July 18, 2011 3:12 PM
> > To: Prafulla Wadaskar
> > Cc: u-boot at lists.denx.de; Ajay Bhargav
> > Subject: [PATCH 3/4] Armada100: Enable 88E3015 PHY support for
> GplugD
> > 
> > This patch adds support for 88E3015 PHY for Marvell GplugD board.
> > 
> > Signed-off-by: Ajay Bhargav <ajay.bhargav@einfochips.com>
> > ---
> >  board/Marvell/gplugd/gplugd.c |   35
> > +++++++++++++++++++++++++++++++++++
> >  include/configs/gplugd.h      |   14 ++++++++++++++
> >  2 files changed, 49 insertions(+), 0 deletions(-)
> > 
> > diff --git a/board/Marvell/gplugd/gplugd.c
> > b/board/Marvell/gplugd/gplugd.c
> > index dc7d89d..347a689 100644
> > --- a/board/Marvell/gplugd/gplugd.c
> > +++ b/board/Marvell/gplugd/gplugd.c
> > @@ -32,6 +32,8 @@
> >  #include <mvmfp.h>
> >  #include <asm/arch/mfp.h>
> >  #include <asm/arch/armada100.h>
> > +#include <asm/gpio.h>
> > +#include <miiphy.h>
> > 
> >  DECLARE_GLOBAL_DATA_PTR;
> > 
> > @@ -49,6 +51,7 @@ int board_early_init_f(void)
> >  	};
> >  	/* configure MFP's */
> >  	mfp_config(mfp_cfg);
> > +
> 
> Remove this unwanted commit line

Okay..

> 
> >  	return 0;
> >  }
> > 
> > @@ -58,5 +61,37 @@ int board_init(void)
> >  	gd->bd->bi_arch_number = MACH_TYPE_SHEEVAD;
> >  	/* adress of boot parameters */
> >  	gd->bd->bi_boot_params = armd1_sdram_base(0) + 0x100;
> > +	/* Assert PHY_RST# */
> > +	gpio_direction_output(CONFIG_SYS_GPIO_PHY_RST, GPIO_CLR);
> > +	udelay(10);
> > +	/* Deassert PHY_RST# */
> > +	gpio_set_value(CONFIG_SYS_GPIO_PHY_RST, GPIO_SET);
> 
> May you please comment why do you need to set this GPIO?

GPIO 104 is connected to reset pin of 88E3015 PHY. and a reset is
required before initializing PHY chip.

Regards,
Ajay Bhargav