[U-Boot] [PATCH v7 15/19] nand: mxc: Switch NAND SPL to generic SPL

["Benoît Thébaudeau" <benoit.thebaudeau@advansee.com>]

Hi Fabio,

On Friday, February 22, 2013 10:06:42 PM, Fabio Estevam wrote:
> Hi Beno?t,
> 
> On Fri, Feb 22, 2013 at 5:09 PM, Beno?t Th?baudeau
> <benoit.thebaudeau@advansee.com> wrote:
> 
> > It looks very much like the issue that Marek had on i.MX53 (which
> > self-resolved
> > for an unknown reason).
> >
> > Try to enable the debug trace to see if anything else is printed after
> > display_dram_config(). I would especially be interested in:
> >         debug("relocation Offset is: %08lx\n", gd->reloc_off);
> >         debug("monitor flash len: %08lX\n", monitor_flash_len);
> 
> Here is the output:
> 
> U-Boot 2013.01 (Feb 22 2013 - 18:00:50)
> 
> U-Boot code: 87F00000 -> 87F2C184  BSS: -> 87F311B4
> CPU:   Freescale i.MX31 rev 2.0 at 532 MHz.
> Reset cause: POR
> Board: MX31PDK
> monitor len: 000311B4
> ramsize: 08000000
> TLB table from 87ff0000 to 87ff4000
> Top of RAM usable for U-Boot at: 87ff0000
> Reserving 196k for U-Boot at: 87fbe000
> Reserving 640k for malloc() at: 87f1e000
> Reserving 32 Bytes for Board Info at: 87f1dfe0
> Reserving 128 Bytes for Global Data at: 87f1df60
> New Stack Pointer is: 87f1df50
> RAM Configuration:
> Bank #0: 80000000 128 MiB
> relocation Offset is: 000be000

CONFIG_SYS_TEXT_BASE seems fine according to this trace. But anyway, can you
test with this change in mx31pdk.h?
#define CONFIG_SPL_TEXT_BASE	0x84000000
#define CONFIG_SYS_TEXT_BASE	0x83000000

Can you try to revert 10/19, only for arm1136/start.S (1 line to restore)? There
is an issue in this patch that I have already fixed in my v8.

Best regards,
Beno?t