From mboxrd@z Thu Jan 1 00:00:00 1970 From: Markus =?iso-8859-1?Q?Klotzb=FCcher?= Date: Tue, 13 Feb 2007 09:44:02 +0100 Subject: [U-Boot-Users] u-boot In-Reply-To: <45D0D40A.4030008@hns.com> (Harshad Poshtiwala's message of "Mon, 12 Feb 2007 15:54:34 -0500") References: <45D0D40A.4030008@hns.com> Message-ID: <8764a630rx.fsf@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Dear Harshad, Harshad Poshtiwala writes: > I am 1st time user of u-boot. > I am to bring up arm-based board. i.e my target board is going to be > based on ARM architecture/ > > I follwed the following steps. > 1,I installed precompiled tool chain on my machine > 2,Built / compile linux kernel. > 3,IBuilt / compile u-boot. > > Now what should be the next step? Run U-Boot and then run Linux. > Is there any document availble to tell me the exact procedure for this. Sure, the U-Boot sources contain a very nice README, and for more Information you can take a look at the DULG: http://www.denx.de/wiki/DULG/WebHome Regards Markus Klotzbuecher