messages from 2010-10-26 19:19:41 to 2010-10-28 11:18:49 UTC [more...]
[U-Boot] [PATCH V3] imx25: Fix reset
2010-10-28 11:18 UTC (5+ messages)
[U-Boot] Most ARM CPU's have buggy clear_bss?
2010-10-28 11:16 UTC (29+ messages)
[U-Boot] Small default of 8MB for CONFIG_SYS_BOOTM_LEN
2010-10-28 11:00 UTC (2+ messages)
[U-Boot] [PATCH 3/3 V3] Add board support for hawkboard
2010-10-28 10:52 UTC (2+ messages)
[U-Boot] [PATCH] MX51: remove warning in clock.c
2010-10-28 10:40 UTC
[U-Boot] [PATCH] env_sf: remove warning introduced with last patch
2010-10-28 10:39 UTC
[U-Boot] [PATCH v2] Kirkwood: bugfix: DRAM size initialization
2010-10-28 10:23 UTC (2+ messages)
[U-Boot] Is the Numonyx's M29W128 fully supported in U-Boot?
2010-10-28 10:18 UTC (2+ messages)
[U-Boot] Does U-boot supports STM28W160C NOR Flash?
2010-10-28 10:07 UTC
[U-Boot] contact my secretary
2010-10-28 10:04 UTC
[U-Boot] [PATCH v2] [RFC] kirkwood: get rid of config.mk files
2010-10-28 9:59 UTC (3+ messages)
[U-Boot] [PATCH V2] Kirkwood: bugfix: broken early console messages
2010-10-28 9:58 UTC (2+ messages)
[U-Boot] [PATCH] kirkwood: guruplug: Relocate NAND environment area
2010-10-28 9:47 UTC (3+ messages)
[U-Boot] A Votre Attention
2010-10-28 9:29 UTC
[U-Boot] [PATCHv2] mpc83xx: Add -fpic relocation support
2010-10-28 8:46 UTC (4+ messages)
` [U-Boot] [PATCHv3] "
[U-Boot] Please pull u-boot-samsung/master
2010-10-28 7:29 UTC
[U-Boot] [PATCH V6] MTD/SPI: add support for Ramtron FRAMs
2010-10-28 7:26 UTC (4+ messages)
[U-Boot] Kernel OOPS on memcpy - bad memory setup?
2010-10-28 6:55 UTC (3+ messages)
[U-Boot] SPI on PPC MPC85xx
2010-10-28 6:44 UTC (6+ messages)
[U-Boot] [PATCH] Add generic support for samsung s3c2440
2010-10-28 6:40 UTC (10+ messages)
` [U-Boot] [PATCH v2] "
` [U-Boot] [PATCH v3] "
` [U-Boot] [PATCH v4] "
` [U-Boot] [PATCH v5] "
[U-Boot] Pull request u-boot-blackfin.git
2010-10-28 6:31 UTC
[U-Boot] [STATUS] v2010.12-rc1 released
2010-10-28 6:06 UTC (3+ messages)
[U-Boot] [PATCH v2] mmc: omap: timeout counter fix
2010-10-28 6:02 UTC (15+ messages)
` [U-Boot] Timer implementations (was: Re: [PATCH v2] mmc: omap: timeout counter fix)
` [U-Boot] Timer implementations
[U-Boot] [PATCH] mmc: new legacy MMC/SPI driver
2010-10-28 3:47 UTC (5+ messages)
[U-Boot] [PATCH 0/5] Add Marvell New Soc Support ARMADA100
2010-10-28 3:28 UTC (11+ messages)
` [U-Boot] [PATCH 1/5] arm: Add Support for Marvell ARMADA 100 Familiy SoCs
` [U-Boot] [PATCH 2/5] Serial: Add UART support for Marvell ARMADA 100 SoCs
` [U-Boot] [PATCH 3/5] gpio: Add Multi-Function-Pin configuration driver for Marvell SoCs
` [U-Boot] [PATCH 4/5] add Multi Fnction Pin configuration support for ARMADA100
` [U-Boot] [PATCH 5/5] Armada100: Add Board Support for Marvell Aspenite-DB
[U-Boot] [PATCH v2] mx51evk: support new relocation scheme
2010-10-28 2:13 UTC (14+ messages)
` [U-Boot] [PATCH v3] "
[U-Boot] [PATCH] Blackfin: fix building after asm-offsets.h intro
2010-10-28 1:17 UTC
[U-Boot] [PATCH] env_sf: updated to the new environment code
2010-10-28 1:12 UTC (3+ messages)
[U-Boot] The due on avew
2010-10-28 0:18 UTC
[U-Boot] [PATCH 01/10 v2] net: rtl8169: Add initialized eth_device structure
2010-10-27 23:47 UTC (4+ messages)
[U-Boot] [PULL] U-Boot-pxa pull request
2010-10-27 22:05 UTC
[U-Boot] [PATCH] arm/pxa: remove unused arch-pxa/macro.h
2010-10-27 22:02 UTC
[U-Boot] [PATCH] arm/pxa: remove unused arch-pxa/macro.h
2010-10-27 21:47 UTC
[U-Boot] [PATCH] Standalone Apps: Standalone apps should need only exports.h
2010-10-27 20:31 UTC (3+ messages)
` [U-Boot] [PATCH v2] "
[U-Boot] [PATCH] mmc: seperate block number into small parts for multi-write cmd
2010-10-27 19:59 UTC (7+ messages)
` [U-Boot] [PATCH V3] "
` [U-Boot] [PATCH V4] "
[U-Boot] [PATCH 1/2] imx: Get fec mac address from fuse
2010-10-27 18:59 UTC (14+ messages)
` [U-Boot] [PATCH 2/2] MX5: board version not printed corretly on MX51EVK
[U-Boot] [PATCH 0/2] Fix onenand command after ARM relocation changes
2010-10-27 18:51 UTC (3+ messages)
` [U-Boot] [PATCH 1/2] cmd_onenand.c: Fix command usage help
[U-Boot] [PATCH 3/3] Replace CONFIG_SYS_GBL_DATA_SIZE by auto-generated value
2010-10-27 18:41 UTC (10+ messages)
` [U-Boot] [PATCH 3/3 v2] "
[U-Boot] Pull request: sparc
2010-10-27 18:38 UTC (2+ messages)
[U-Boot] [PATCH] Makefile: fix dependencies for building NAND_SPL
2010-10-27 18:18 UTC (3+ messages)
[U-Boot] [PATCH] make-asm-offsets: fix sed script
2010-10-27 18:17 UTC (4+ messages)
[U-Boot] [PATCH] mcu25: fix out of tree building
2010-10-27 18:15 UTC (3+ messages)
[U-Boot] [PATCH v2 07/13] post/i2c: Clean up detection logic
2010-10-27 18:09 UTC (4+ messages)
` [U-Boot] [PATCH] post/drivers/i2c.c: fix compile error
[U-Boot] [PATCH 3/3] mpc83xx: turn on icache in core initialization to improve u-boot boot time
2010-10-27 17:42 UTC (10+ messages)
` [U-Boot] [PATCH 3/3 v2] "
` [U-Boot] ICACHE in core initialization to improve u-boot boot time: Breaks booting with i2c code while executing in flash
[U-Boot] [PATCH RFC] ARMV7: OMAP: Fix build after introduction of GENERATED_GBL_DATA_SIZE
2010-10-27 17:32 UTC (6+ messages)
[U-Boot] [PATCH] mx51evk: Fix 2 hours reset issue
2010-10-27 15:36 UTC
[U-Boot] [PATCH] VoVPN-GW_100MHz: drop unsupported board configuration
2010-10-27 15:17 UTC (4+ messages)
[U-Boot] [PATCH v2] omap3evm: Support for quick boot
2010-10-27 15:02 UTC (4+ messages)
[U-Boot] [PATCH] da850evm: remove GENERATED_GBL_DATA_SIZE from initial stack
2010-10-27 14:42 UTC (3+ messages)
[U-Boot] [PATCH] usb: fix usb start problem with SMSC USB hub and Toshiba USB stick
2010-10-27 13:05 UTC (3+ messages)
[U-Boot] arm, omap3, beagle: initial stack pointer setup
2010-10-27 13:04 UTC (7+ messages)
[U-Boot] Mail list threading problem or mailer problem?
2010-10-27 12:59 UTC (2+ messages)
[U-Boot] [PATCH] mx51evk: consolidate env for mmcboot and netboot
2010-10-27 11:19 UTC (2+ messages)
[U-Boot] [RFC PATCH 0/3] Add device tree support for ARM to U-Boot
2010-10-27 10:50 UTC (6+ messages)
` [U-Boot] [RFC 1/3] FDT: Add fixup support of multiple banks of memory
` [U-Boot] [RFC] [PATCH 0/4] Add support for Freescale's 85xx and P1/P2xxx eSPI controller
[U-Boot] Your Mail ID Has Won £1,000,000.00. in The BT PROMO.Send
2010-10-27 9:07 UTC
[U-Boot] [PATCH 1/6] GRETH: removed unneccesary register write and one clean up
2010-10-27 8:23 UTC (6+ messages)
` [U-Boot] [PATCH 2/6] GRETH: made debug printouts use common debug() macro
` [U-Boot] [PATCH 3/6] GRETH: Added autodetection of PHY address, or let BSP hardcode it
` [U-Boot] [PATCH 4/6] GRETH: Added extra RESET, this is needed if GRETH was stopped during an ethernet frame reception
` [U-Boot] [PATCH 5/6] GRETH: fixed 2 decriptor table typos
` [U-Boot] [PATCH 6/6] GRETH: removed space in network driver device name
[U-Boot] current ARM development head
2010-10-27 7:51 UTC (3+ messages)
[U-Boot] [PATCH] sparc: add asm/unaligned.h
2010-10-27 7:44 UTC (4+ messages)
[U-Boot] [PATCH 1/3] mpc8641hpcn: Update PCI code
2010-10-27 6:47 UTC (5+ messages)
` [U-Boot] [PATCH 3/3] tqm85xx: "
[U-Boot] [PATCH 2/3 V3] Make board_init_f under nand_boot.c a weak function
2010-10-27 5:58 UTC (3+ messages)
[U-Boot] Medical Equipment Suppliers - 167, 425 total records with 6, 940 emails and 5, 812 fax numbers
2010-10-27 3:40 UTC
[U-Boot] American Consumer email lists
2010-10-27 3:36 UTC
[U-Boot] Detailed data with many fields for businesses, healthcare and more
2010-10-27 2:13 UTC
[U-Boot] [PATCH] cmd_net: drop spurious comma in U_BOOT_CMD
2010-10-27 0:45 UTC (4+ messages)
[U-Boot] [PATCH v6] POST cleanup
2010-10-26 21:09 UTC (3+ messages)
` [U-Boot] [PATCH V7] "
[U-Boot] [PATCH v6 0/10] PPC LBC/TLB cleanups; reginfo command for 85xx
2010-10-26 20:29 UTC (7+ messages)
` [U-Boot] [PATCH V6 01/10] powerpc: Update configs to properly set FSL_ELBC
` [U-Boot] [PATCH V6 02/10] drivers/usb/host/ohci-hcd: undef readl/writel before redefining
` [U-Boot] [PATCH V6 03/10] 83xx/85xx/86xx: LBC register cleanup
[U-Boot] [PATCH] ARM: use the same branch insn on all architectures
2010-10-26 19:19 UTC (2+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox