messages from 2012-02-04 08:07:49 to 2012-02-06 22:59:17 UTC [more...]
[U-Boot] flash post test
2012-02-06 22:59 UTC (6+ messages)
[U-Boot] [PATCH 3/6] cm-t35: add EEPROM module and pass Linux a serial number
2012-02-06 22:56 UTC (5+ messages)
` [U-Boot] [PATCH v2 "
[U-Boot] http://patchwork.ozlabs.org/patch/136415/ seems to break HUSH parser?
2012-02-06 22:43 UTC
[U-Boot] Skipping relocation RAM to RAM, esp. on i.MX6?
2012-02-06 22:41 UTC (17+ messages)
` [U-Boot] i.MX5/6 U-Boot: Cache enabling (was: Re: Skipping relocation RAM to RAM, esp. on i.MX6?)
` [U-Boot] i.MX5/6 U-Boot: Cache enabling
[U-Boot] Can u-Boot Ran from RAM?
2012-02-06 22:37 UTC (5+ messages)
[U-Boot] [PATCH] arm: Add option to disable code relocation
2012-02-06 22:24 UTC (22+ messages)
[U-Boot] [patch] ARM: Faraday SoC support
2012-02-06 22:07 UTC
[U-Boot] timer problem with new ARM relocation feature
2012-02-06 21:53 UTC (6+ messages)
` [U-Boot] [PATCH] ARM: activate DISPLAY_CPUINFO for VCMA9 + SMDK2410 board
` [U-Boot] [PING] "
[U-Boot] [PATCH 1/2] RFC: create u-boot-common.lds
2012-02-06 21:44 UTC (21+ messages)
` [U-Boot] [PATCH 2/2] RFC: Let linker create phy array
[U-Boot] [PATCH v2 0/7] tegra: Add I2C driver and associated parts
2012-02-06 21:41 UTC (5+ messages)
` [U-Boot] [PATCH v2 4/7] tegra: Add I2C driver
[U-Boot] [GIT PULL] Pull request: u-boot-imx
2012-02-06 21:29 UTC (5+ messages)
` [U-Boot] [UPDATED] "
[U-Boot] [RFC PATCH 0/4] Enable Thumb build for ARM platforms
2012-02-06 21:06 UTC (9+ messages)
` [U-Boot] [RFC PATCH 1/4] ARM: enable Thumb build
` [U-Boot] [RFC PATCH 2/4] OMAP3+: fix issues with "
` [U-Boot] [RFC PATCH 3/4] OMAP3+: Use -march=armv7-a and thereby enable Thumb-2
` [U-Boot] [RFC PATCH 4/4] OMAP4: enable Thumb build
[U-Boot] [PATCH] davinci: cleanup davinci_sync_env_enetaddr() fucntion
2012-02-06 19:24 UTC (2+ messages)
[U-Boot] Integity validation (checksum) of a squashfs root file system
2012-02-06 18:41 UTC (4+ messages)
[U-Boot] [PATCH] i.MX28: digctrl registers added
2012-02-06 18:40 UTC (4+ messages)
` [U-Boot] [PATCH] Elimintated magic numbers for scratch register addresses
[U-Boot] Integity validation (checksum) of a squashfs root file system
2012-02-06 16:03 UTC
[U-Boot] [PATCH 4/4 v3] i.MX28: Fix ref_cpu clock setup
2012-02-06 15:57 UTC (3+ messages)
[U-Boot] [PATCH 3/4 v3] i.MX28: Fix ref_cpu clock setup
2012-02-06 15:35 UTC (2+ messages)
[U-Boot] [PATCH 2/4 v3] i.MX28: Fix ref_cpu clock setup
2012-02-06 15:33 UTC (2+ messages)
[U-Boot] [PATCH V2] mx28: fix SPL code to make USB booting work
2012-02-06 15:29 UTC (2+ messages)
[U-Boot] [PATCH] OMAP4460: Reduce MPU clock speed from 920 to 700
2012-02-06 15:07 UTC
[U-Boot] [PATCH 1/4 v3] i.MX28: Fix ref_cpu clock setup
2012-02-06 14:57 UTC
[U-Boot] [PATCH] OMAP3: TAM3517: update ehci interface
2012-02-06 14:55 UTC (2+ messages)
[U-Boot] [PATCH 1/2] v2 i.MX28: Fix ref_cpu clock setup
2012-02-06 14:40 UTC (11+ messages)
[U-Boot] [PATCH] mx6qarm2: fix build error for board_mmc_getcd()
2012-02-06 14:14 UTC (6+ messages)
[U-Boot] [PATCH v4 0/7] Add and Clean up ehci-omap and extend support for omap3/4 socs
2012-02-06 13:55 UTC (8+ messages)
` [U-Boot] [PATCH v4 1/7] usb: ulpi: Extend the existing ulpi framework
` [U-Boot] [PATCH v4 2/7] usb: ulpi: Add omap-ulpi-view port support
` [U-Boot] [PATCH v4 3/7] ehci-omap: driver for EHCI host on OMAP3
` [U-Boot] [PATCH v4 4/7] ehci-omap: Clean up added ehci-omap.c
` [U-Boot] [PATCH v4 5/7] OMAP3+: Clock: Adding ehci clock enabling
` [U-Boot] [PATCH v4 6/7] OMAP4: clock-common: Move the usb dppl configuration to new func
` [U-Boot] [PATCH v4 7/7] OMAP4: ehci-omap: enable ehci-omap for panda boards
[U-Boot] [PATCH] Ethernut 5: fix build error for board_mmc_getcd()
2012-02-06 13:38 UTC (2+ messages)
[U-Boot] [PATCH 1/3] mx28evk: add RTC support
2012-02-06 13:11 UTC (4+ messages)
[U-Boot] [PATCH V6 2/2] mcx: support for HTKW mcx board
2012-02-06 12:42 UTC (3+ messages)
` [U-Boot] [PATCH V7] "
[U-Boot] [PATCH v3 0/7] Clean up ehci-omap and extend support for omap3/4 socs
2012-02-06 12:17 UTC (15+ messages)
` [U-Boot] [PATCH v3 2/7] ehci-omap: Clean up added ehci-omap.c
` [U-Boot] [PATCH v3 3/7] OMAP3+: Clock: Adding ehci clock enabling
` [U-Boot] [PATCH v3 5/7] OMAP3+: ehci-omap: enable usb host ports for beagle/panda
` [U-Boot] [PATCH v3 6/7] usb: ulpi: Extend the existing ulpi framework
` [U-Boot] [PATCH v3 7/7] usb: ulpi: Add omap-ulpi-view port support
[U-Boot] [PATCH 1/3] MX35: add missing get_ticks() and get_tbclk()
2012-02-06 12:02 UTC (3+ messages)
` [U-Boot] [PATCH 2/3] MX31: add missing get_tbclk()
` [U-Boot] [PATCH 3/3] MX5/MX6: add missing get_ticks() and get_tbclk()
[U-Boot] [PATCH v4 1/5] net: fec_mxc: add 1000 Mbps selection
2012-02-06 10:47 UTC (3+ messages)
[U-Boot] [PATCH v2 0/2] add support for printing of clock information as part of 'bdinfo' command
2012-02-06 10:30 UTC (3+ messages)
` [U-Boot] [PATCH v2 1/2] davinci: remove macro CONFIG_DISPLAY_CPUINFO
` [U-Boot] [PATCH v2 2/2] davinci: add support for printing clock frequency
[U-Boot] [PATCH v9 0/4] Add SMDK5250 board support
2012-02-06 9:01 UTC (5+ messages)
` [U-Boot] [PATCH v9 1/4] Exynos: Clock.c: Use CONFIG_SYS_CLK_FREQ macro
` [U-Boot] [PATCH v9 2/4] ARM: EXYNOS: Add support for Exynos5 based SoCs
` [U-Boot] [PATCH v9 3/4] EXYNOS: Add SMDK5250 board support
` [U-Boot] [PATCH v9 4/4] EXYNOS: SMDK5250: Add MMC SPL support
[U-Boot] [PATCH] add STM29F400BB to table of supported legacy flashs
2012-02-06 8:42 UTC
[U-Boot] [PATCH 0/2] mmc: card status polling fixes
2012-02-06 8:29 UTC (3+ messages)
` [U-Boot] [PATCH 1/2] mmc: fix card busy polling
` [U-Boot] [PATCH 2/2] mmc: make mmc_send_status() more reliable
[U-Boot] [PATCH V4] AT91: pio: Add PIO3 features
2012-02-06 8:14 UTC (2+ messages)
[U-Boot] [PATCH v2 0/20] tegra: warmboot (suspend / resume) support
2012-02-06 7:11 UTC (5+ messages)
` [U-Boot] [PATCH v2 18/20] tegra: i2c: Add function to find DVC bus
[U-Boot] [PATCH] sh: i2c: Add support I2C controller of SH7734
2012-02-06 6:52 UTC (2+ messages)
[U-Boot] [PATCH v8 0/4] Add SMDK5250 board support
2012-02-06 6:16 UTC (4+ messages)
` [U-Boot] [PATCH v8 4/4] EXYNOS: SMDK5250: Add MMC SPL support
[U-Boot] [PATCH] TRATS: set gpio of UART correctly
2012-02-06 6:06 UTC (2+ messages)
[U-Boot] [PATCH 0/2] da850evm: add board specific functions
2012-02-06 5:04 UTC (3+ messages)
[U-Boot] ARM ld: .bss overlaps section .rel.dyn
2012-02-05 16:05 UTC (8+ messages)
[U-Boot] Avoiding reload on ARM U-BOOT
2012-02-05 15:09 UTC (6+ messages)
[U-Boot] [PATCH v4] Add 'patman' patch generation, checking and submission script
2012-02-05 5:46 UTC (6+ messages)
[U-Boot] [PATCH 1/2] easylogo: add lzma support
2012-02-05 3:36 UTC (6+ messages)
` [U-Boot] [PATCH 2/2] Blackfin: easylogo: add lzma logos
[U-Boot] [PATCH v4 0/9] Unified command execution in one place
2012-02-05 3:25 UTC (11+ messages)
` [U-Boot] [PATCH v4 2/9] Rename run_command() to builtin_run_command()
` [U-Boot] [PATCH v4 4/9] Stop using builtin_run_command()
` [U-Boot] [PATCH v4 5/9] Don't include standard parser if hush is used
` [U-Boot] [PATCH v4 6/9] Create a single cmd_call() function to handle command execution
` [U-Boot] [PATCH v4 7/9] Remove interleave of non-U-Boot code in hush
[U-Boot] [PATCH 00/14] Nokia RX-51 support
2012-02-04 15:05 UTC (3+ messages)
[U-Boot] [PATCH] mx28: fix SPL code to make USB booting work
2012-02-04 14:16 UTC (4+ messages)
[U-Boot] SPL Linux Boot
2012-02-04 10:22 UTC (14+ messages)
` [U-Boot] SPL Linux Boot V13
` [U-Boot] [PATCH V13 01/12] Add cmd_spl command
` [U-Boot] [PATCH V13 02/12] devkit8000: add config for spl command
` [U-Boot] [PATCH V13 03/12] omap-common: Add NAND SPL linux booting
` [U-Boot] [PATCH V13 04/12] devkit8000/spl: init GPMC for dm9000 in SPL
` [U-Boot] [PATCH V13 05/12] omap-common/spl: Add linux boot to SPL
` [U-Boot] [PATCH V13 06/12] omap/spl: change output of spl_parse_image_header
` [U-Boot] [PATCH V13 07/12] devkit8000: Implement and activate direct OS boot
` [U-Boot] [PATCH V13 08/12] Add cache functions to SPL for armv7
` [U-Boot] [PATCH V13 09/12] OMAP3: SPL: do not call I2C init if no I2C is set
` [U-Boot] [PATCH V13 10/12] SPL: call cleanup_before_linux() before booting Linux
` [U-Boot] [PATCH V13 11/12] OMAP3: twister: add support to boot Linux from SPL
` [U-Boot] [PATCH V13 12/12] arm: Add Prep subcommand support to bootm
[U-Boot] [PATCH 1/4] fpga: add definition for Xilinx Spartan-6 XC6SLX4
2012-02-04 8:22 UTC (2+ messages)
` [U-Boot] [PATCH V4] ARM: omap3: Added Teejet mt_ventoux
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox