From mboxrd@z Thu Jan 1 00:00:00 1970 From: Ranjit Deshpande Date: Fri, 18 Jan 2008 13:13:15 -0800 Subject: [U-Boot-Users] U-boot on Avila GW2355 platform : UART not working In-Reply-To: <4791102C.5090608@solectek> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Mahesh, I am not aware of the GW2355 and if it was a custom design since Gateworks does do custom boards. For their current "retail" offerings I had posted a patch a few months ago: http://article.gmane.org/gmane.comp.boot-loaders.u-boot/30313/match=avila Hope it helps. -Ranjit On 1/18/08 12:46 PM, "Mahesh Kumar" wrote: > Hi, > > Has anybody done the u-boot porting on Avila platforms. I have GW2355, > which is based on IXP425 CPU. > > I have used the existing IXDP425 support from the u-boot, and could get > the console messages till the prompt. But the problem is I could not > write anything in the console. I could see that the serial_getc() is > looping around to get a character in the UART receive buffer. Since the > "data ready bit" is not set, the loop is like a forever type. > > Any idea on this matter ?. > > Thanks in advance. > > Regards, > Mahesh. > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > U-Boot-Users mailing list > U-Boot-Users at lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/u-boot-users