[U-Boot] [PATCH v2] gpio: spear_gpio: Fix gpio_set_value() implementation

[Albert ARIBAUD <albert.u.boot@aribaud.net>]

Hi Axel,

On Mon, 16 Sep 2013 08:35:41 +0800, Axel Lin <axel.lin@ingics.com>
wrote:

> In current gpio_set_value() implementation, it always sets the gpio control bit
> no matter the value argument is 0 or 1. Thus the GPIOs never set to low.
> This patch fixes this bug.
> 
> The address bus is used as a mask on read/write operations, so that independent
> software drivers can set their GPIO bits without affecting any other pins in a
> single write operation. Thus we don't need a read-modify-write to update the
> register.
> 
> Signed-off-by: Axel Lin <axel.lin@ingics.com>
> Acked-by: Stefan Roese <sr@denx.de>
> Reviewed-by: Vipin Kumar <vipin.kumar@st.com>
> Reviewed-by: Michael Trimarchi <michael@amarulasolutions.com>
> ---
> v2: Update commit log to explain why a read-modify-write is not necessary
>     for clearing specific GPIO bit.
>     Also added Michael Trimarchi's reviewed-by tag since he does review the
>     patch and said the patch is fine.
> 
>  drivers/gpio/spear_gpio.c | 5 ++++-
>  1 file changed, 4 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/gpio/spear_gpio.c b/drivers/gpio/spear_gpio.c
> index 367b670..6fb4117 100644
> --- a/drivers/gpio/spear_gpio.c
> +++ b/drivers/gpio/spear_gpio.c
> @@ -36,7 +36,10 @@ int gpio_set_value(unsigned gpio, int value)
>  {
>  	struct gpio_regs *regs = (struct gpio_regs *)CONFIG_GPIO_BASE;
>  
> -	writel(1 << gpio, &regs->gpiodata[DATA_REG_ADDR(gpio)]);
> +	if (value)
> +		writel(1 << gpio, &regs->gpiodata[DATA_REG_ADDR(gpio)]);
> +	else
> +		writel(0, &regs->gpiodata[DATA_REG_ADDR(gpio)]);
>  
>  	return 0;
>  }

Applied to u-boot-arm/master, thanks!

Amicalement,
-- 
Albert.