[U-Boot] Splash Screen

[Schmid Alexander <a.schmid@systeme-steuerungen.de>]

-----Urspr?ngliche Nachricht-----
Von: Anatolij Gustschin [mailto:agust at denx.de]
Gesendet: Freitag, 24. Oktober 2008 11:21
An: a.schmid at systeme-steuerungen.de
Cc: Wolfgang Denk; u-boot at lists.denx.de
Betreff: Re: [U-Boot] Splash Screen


Hello,

Schmid Alexander wrote:

>>>> Because when i press a key (between the 3 seconds of autostart) the
>> splash
>>>> screen picture stays there, and I don`t see any console output!
>>
>>> Try typing (blind):
>>>
>>>
>>> 	setenv stdout lcd
>>>
>>> (followed by ENTER). What happens?
>>
>> When I type blind, the U-Boot acts normally( e.g reset or run
bcmd_flash).
>> But nothing happens if I do a"setenv stdout lcd".
>> What could the reason be?

>Maybe you should use "vga" instead of "lcd". Try:

>	setenv stdout vga

OK thank you. It works. I played with the variables a time ago, and thought
today, the whole morning, sdtout lcd sounds a little bit strange. But
unfortunately "vga" was not in my head!
Do you know were I could place the setenv stdout vga, that it will be
automatically loaded when the 3 seconds autostart get interrupted from a
key?



Thanks very much.

Best regards,
Anatolij

--
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de