[U-Boot-Users] ECC DIMM's with walnut board

["Thomas Schäfer" <tschaefer@giga-stream.de>]

Hi all,

I compiled u-boot 0.3.0 for the walnut board and run it, it was working fine. Then I replaced the shipped 32MB DIMM module with a 256MB DIMM module with ECC and the board hang:

U-Boot 0.3.0 (Apr 25 2003 - 12:10:17)

CPU:   IBM PowerPC 405GP Rev. E at 200 MHz (PLB=100, OPB=50, EBC=50 MHz)
           PCI sync clock at 33 MHz, internal PCI arbiter enabled
           16 kB I-Cache 8 kB D-Cache
Board: WALNUT405-EVB_22
I2C:   ready
DRAM:  256 MB
***hang***

I examined the function spd_sdram in cpu/ppc4xx/spd_sdram.c and found that the ECC Correction Enable bits in the SDRAM0_ECCCFG register are set to 1 when ECC DIMM is detected. I removed this setting and the board was working without any problems.
The 405GP Reference board manual says that using an ECC DIMM on a walnut board, only half of the total DIMM size is available if it is enabled for ECC, but this seems not to work on my board.

Has anyone tried out to run the walnut board with ECC DIMM's? What DIMM's did you use? The DIMM I was trying is Infineon HYS72V32220GU (256MB, PC133-222-520).

Best regards

Thomas Sch?fer

____________________________________

GIGA STREAM - UMTS Technologies GmbH

Konrad-Zuse-Str. 7
66115 Saarbr?cken

Tel.: + 49 (0)681 / 95916 - 203
Fax:  + 49 (0)681 / 95916 - 100
E-mail: tschaefer at giga-stream.de

-------------- next part --------------
A non-text attachment was scrubbed...
Name: smime.p7s
Type: application/x-pkcs7-signature
Size: 3015 bytes
Desc: not available
Url : http://lists.denx.de/pipermail/u-boot/attachments/20030425/761c24da/attachment.bin