[U-Boot-Users] Problem with flash cfi legacy mode

[Tor Krill <tor@excito.com>]

On 3/14/2008, "Michael Schwingen" <rincewind@discworld.dascon.de> wrote:

>Tor Krill wrote:
>> Im working on adding support for our board to u-boot.
>>
>> I use legacy flash mode for our boot-flash. I however have some problems
>> with it.
>>
>> When using jedec probe to identify our flash. Im unable to do so with our
>> 16bit device-id. In my opinion it seems like this actually wont work(?)
>>
>> cmdset_amd_read_jedec_ids uses _one_ flash_read_uchar call to read out
>> the device id(, if its not an amd extended one). The only way i could
>> get this to work with our flash was to only put the lower 8bit in the
>> dev_id field when adding an entry to the jedec_table.
>>
>Hm - right. You are probably the first one to use that code on a 16-bit
>non-CFI flash - for 16-bit flashs, the read will need to be changed, but
>I am not sure how exactly - I think we may need separate code depending
>on info->chipwidth, because 8-bit flashs only have an 8-bit ID.

Can one asume that a chip with chipwidht 16 always has an ID of 16bit?
And how does AMD expanded 3byte id mode fit?  If its safe to just change
the read   it should be trivial to fix(?)

>> Further on it seems like CFI_CMDSET_AMD_LEGACY is unsupported in
>> flash_write_cfibuffer.
>>
>Right. Setting info->buffer_size = 1 in jedec_flash.c/fill_info() should
>make sure that part of code is never executed.

Ok, i just skipped CFG_FLASH_USE_BUFFER_WRITE instead. That solved it for
me.

/Tor