[U-Boot] [PATCH 3/3] usb: musb-new: omap2430: Fix compilation warning with USB_MUSB_GADGET

[Marek Vasut <marek.vasut@gmail.com>]

On 5/29/19 1:16 AM, Derald Woods wrote:
> On Tue, May 28, 2019 at 4:16 PM Marek Vasut <marek.vasut@gmail.com> wrote:
>>
>> On 5/28/19 4:22 AM, Derald D. Woods wrote:
>>> This commit addresses the following warning, when _NOT_ USB_MUSB_HOST:
>>>
>>> [...]
>>>   CC      drivers/usb/gadget/f_mass_storage.o
>>>   CC      drivers/usb/musb-new/omap2430.o
>>>   CC      drivers/usb/gadget/f_fastboot.o
>>>   CC      env/common.o
>>>   CC      env/env.o
>>> /src/etinker/software/u-boot-master/drivers/usb/musb-new/omap2430.c: In function ‘omap2430_musb_probe’:
>>> /src/etinker/software/u-boot-master/drivers/usb/musb-new/omap2430.c:239:6: warning: assignment to ‘int’ from ‘struct musb *’ makes integer from pointer without a cast [-Wint-conversion]
>>>   ret = musb_register(&platdata->plat,
>>>       ^
>>>   LD      drivers/usb/host/built-in.o
>>>   CC      drivers/usb/gadget/f_sdp.o
>>>   CC      fs/ext4/ext4fs.o
>>> [...]

Skip to the end first

>>> Signed-off-by: Derald D. Woods <woods.technical@gmail.com>
>>> ---
>>>  drivers/usb/musb-new/omap2430.c | 8 ++++++--
>>>  1 file changed, 6 insertions(+), 2 deletions(-)
>>>
>>> diff --git a/drivers/usb/musb-new/omap2430.c b/drivers/usb/musb-new/omap2430.c
>>> index 32743aa72c..cca1653f1e 100644
>>> --- a/drivers/usb/musb-new/omap2430.c
>>> +++ b/drivers/usb/musb-new/omap2430.c
>>> @@ -215,11 +215,13 @@ static int omap2430_musb_probe(struct udevice *dev)
>>>  {
>>>  #ifdef CONFIG_USB_MUSB_HOST
>>>       struct musb_host_data *host = dev_get_priv(dev);
>>> +#else
>>> +     struct musb *musbp;

Drop this hunk

>>>  #endif
>>>       struct omap2430_musb_platdata *platdata = dev_get_platdata(dev);
>>>       struct usb_bus_priv *priv = dev_get_uclass_priv(dev);
>>>       struct omap_musb_board_data *otg_board_data;
>>> -     int ret;
>>> +     int ret = 0;
>>>       void *base = dev_read_addr_ptr(dev);
>>>
>>>       priv->desc_before_addr = true;
>>> @@ -236,9 +238,11 @@ static int omap2430_musb_probe(struct udevice *dev)
>>>
>>>       ret = musb_lowlevel_init(host);
>>>  #else
>>> -     ret = musb_register(&platdata->plat,
>>> +     musbp = musb_register(&platdata->plat,

Replace musbp with host->host

>>>                         (struct device *)otg_board_data,
>>>                         platdata->base);
>>> +     if (IS_ERR_OR_NULL(musbp))

here too

>>> +             return -EINVAL;
>>
>> For example the pic32 glue code holds the musb_host_data in private data
>> , so it can call musb_stop() in .remove callback . Can you do the same?
>>
> 
> This was just a non-structural change to eliminate a compiler warning.
> I agree that other things can/should be done with this driver. That
> work would be outside of what I was trying to accomplsh here, at the
> moment.

See above, I believe that should fix the problem _and_ not crash in the
.remove() .

-- 
Best regards,
Marek Vasut