From: <Eugen.Hristev@microchip.com>
To: <clement.leger@bootlin.com>, <Ludovic.Desroches@microchip.com>
Cc: <u-boot@lists.denx.de>, <Nicolas.Ferre@microchip.com>,
<thomas.petazzoni@bootlin.com>, <Claudiu.Beznea@microchip.com>
Subject: Re: [PATCH v7 4/4] configs: sama5d2: enable option CONFIG_ATMEL_TCB_TIMER
Date: Tue, 22 Mar 2022 11:18:39 +0000 [thread overview]
Message-ID: <c5fef41b-51b2-ead4-96c2-eb8f23a3f459@microchip.com> (raw)
In-Reply-To: <20220311093539.72669-5-clement.leger@bootlin.com>
On 3/11/22 11:35 AM, Clément Léger wrote:
> Enable CONFIG_ATMEL_TCB_TIMER and disable CONFIG_ATMEL_PIT_TIMER.
> This will allow using the TCB timer instead of the PIT one when running
> under OP-TEE.
Hello Clement,
We have to make sure that the PIT_TIMER was not mandatory for SPL
operations, and if it was, the TCB_TIMER successfully replaces it.
If we have the PIT_TIMER with the u-boot property
u-boot,dm-pre-reloc;
then the PIT_TIMER is available in the SPL and the SPL works :
RomBOOT
;4▒ls▒K{▒KOp▒C▒▒
<debug_uart>
U-Boot SPL 2022.04-rc4-00204-g5f7086d8a8-dirty (Mar 22 2022 - 13:10:58
+0200)
SPL: Unsupported Boot Device!
SPL: failed to boot from all boot devices
(well, it fails to boot because I removed the MMC drivers to have it
smaller than 64k, but it boots)
However, with your patches, even if I add the pre-reloc property to the
tcb nodes, it fails to boot:
RomBOOT
;4▒Ls▒k{▒kOp▒C▒▒
<debug_uart>
Could not initialize timer (err -22)
Could not initialize timer (err -22)
Could not initialize timer (err -22)
Could not initialize timer (err -22)
...
Could you investigate this please ?
Otherwise we cannot switch to using the TCB if it does not fully replace
the PIT_TIMER in all the use cases.
Thanks,
Eugen
>
> Reviewed-by: Claudiu Beznea <claudiu.beznea@microchip.com>
> Signed-off-by: Clément Léger <clement.leger@bootlin.com>
> ---
> configs/sama5d2_icp_mmc_defconfig | 2 +-
> configs/sama5d2_ptc_ek_mmc_defconfig | 2 +-
> configs/sama5d2_ptc_ek_nandflash_defconfig | 2 +-
> configs/sama5d2_xplained_emmc_defconfig | 2 +-
> configs/sama5d2_xplained_mmc_defconfig | 2 +-
> configs/sama5d2_xplained_qspiflash_defconfig | 2 +-
> configs/sama5d2_xplained_spiflash_defconfig | 2 +-
> 7 files changed, 7 insertions(+), 7 deletions(-)
>
> diff --git a/configs/sama5d2_icp_mmc_defconfig b/configs/sama5d2_icp_mmc_defconfig
> index 7761a57e0c..c035d7aad8 100644
> --- a/configs/sama5d2_icp_mmc_defconfig
> +++ b/configs/sama5d2_icp_mmc_defconfig
> @@ -82,6 +82,6 @@ CONFIG_DEBUG_UART_ANNOUNCE=y
> CONFIG_ATMEL_USART=y
> CONFIG_TIMER=y
> CONFIG_SPL_TIMER=y
> -CONFIG_ATMEL_PIT_TIMER=y
> +CONFIG_ATMEL_TCB_TIMER=y
> CONFIG_OF_LIBFDT_OVERLAY=y
> # CONFIG_EFI_LOADER_HII is not set
> diff --git a/configs/sama5d2_ptc_ek_mmc_defconfig b/configs/sama5d2_ptc_ek_mmc_defconfig
> index 9f458e100b..7cb5ba37f6 100644
> --- a/configs/sama5d2_ptc_ek_mmc_defconfig
> +++ b/configs/sama5d2_ptc_ek_mmc_defconfig
> @@ -71,7 +71,7 @@ CONFIG_DM_SERIAL=y
> CONFIG_DEBUG_UART_ANNOUNCE=y
> CONFIG_ATMEL_USART=y
> CONFIG_TIMER=y
> -CONFIG_ATMEL_PIT_TIMER=y
> +CONFIG_ATMEL_TCB_TIMER=y
> CONFIG_USB=y
> CONFIG_USB_EHCI_HCD=y
> CONFIG_USB_STORAGE=y
> diff --git a/configs/sama5d2_ptc_ek_nandflash_defconfig b/configs/sama5d2_ptc_ek_nandflash_defconfig
> index 6460ff3dad..667a10e93f 100644
> --- a/configs/sama5d2_ptc_ek_nandflash_defconfig
> +++ b/configs/sama5d2_ptc_ek_nandflash_defconfig
> @@ -71,7 +71,7 @@ CONFIG_DM_SERIAL=y
> CONFIG_DEBUG_UART_ANNOUNCE=y
> CONFIG_ATMEL_USART=y
> CONFIG_TIMER=y
> -CONFIG_ATMEL_PIT_TIMER=y
> +CONFIG_ATMEL_TCB_TIMER=y
> CONFIG_USB=y
> CONFIG_USB_EHCI_HCD=y
> CONFIG_USB_STORAGE=y
> diff --git a/configs/sama5d2_xplained_emmc_defconfig b/configs/sama5d2_xplained_emmc_defconfig
> index 844a9cde64..72544b65bb 100644
> --- a/configs/sama5d2_xplained_emmc_defconfig
> +++ b/configs/sama5d2_xplained_emmc_defconfig
> @@ -90,7 +90,7 @@ CONFIG_DM_SPI=y
> CONFIG_ATMEL_QSPI=y
> CONFIG_TIMER=y
> CONFIG_SPL_TIMER=y
> -CONFIG_ATMEL_PIT_TIMER=y
> +CONFIG_ATMEL_TCB_TIMER=y
> CONFIG_USB=y
> CONFIG_USB_EHCI_HCD=y
> CONFIG_USB_STORAGE=y
> diff --git a/configs/sama5d2_xplained_mmc_defconfig b/configs/sama5d2_xplained_mmc_defconfig
> index 0de0636587..bcdb84ce2c 100644
> --- a/configs/sama5d2_xplained_mmc_defconfig
> +++ b/configs/sama5d2_xplained_mmc_defconfig
> @@ -92,7 +92,7 @@ CONFIG_DM_SPI=y
> CONFIG_ATMEL_QSPI=y
> CONFIG_TIMER=y
> CONFIG_SPL_TIMER=y
> -CONFIG_ATMEL_PIT_TIMER=y
> +CONFIG_ATMEL_TCB_TIMER=y
> CONFIG_USB=y
> CONFIG_USB_EHCI_HCD=y
> CONFIG_USB_STORAGE=y
> diff --git a/configs/sama5d2_xplained_qspiflash_defconfig b/configs/sama5d2_xplained_qspiflash_defconfig
> index a6e002e59e..c30a90a3e1 100644
> --- a/configs/sama5d2_xplained_qspiflash_defconfig
> +++ b/configs/sama5d2_xplained_qspiflash_defconfig
> @@ -91,7 +91,7 @@ CONFIG_DM_SPI=y
> CONFIG_ATMEL_QSPI=y
> CONFIG_TIMER=y
> CONFIG_SPL_TIMER=y
> -CONFIG_ATMEL_PIT_TIMER=y
> +CONFIG_ATMEL_TCB_TIMER=y
> CONFIG_USB=y
> CONFIG_USB_EHCI_HCD=y
> CONFIG_USB_STORAGE=y
> diff --git a/configs/sama5d2_xplained_spiflash_defconfig b/configs/sama5d2_xplained_spiflash_defconfig
> index 676385fe55..eae54469f8 100644
> --- a/configs/sama5d2_xplained_spiflash_defconfig
> +++ b/configs/sama5d2_xplained_spiflash_defconfig
> @@ -95,7 +95,7 @@ CONFIG_DM_SPI=y
> CONFIG_ATMEL_QSPI=y
> CONFIG_TIMER=y
> CONFIG_SPL_TIMER=y
> -CONFIG_ATMEL_PIT_TIMER=y
> +CONFIG_ATMEL_TCB_TIMER=y
> CONFIG_USB=y
> CONFIG_USB_EHCI_HCD=y
> CONFIG_USB_STORAGE=y
> --
> 2.34.1
>
next prev parent reply other threads:[~2022-03-22 11:19 UTC|newest]
Thread overview: 11+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-03-11 9:35 [PATCH v7 0/4] add TCB driver for sama5d2 Clément Léger
2022-03-11 9:35 ` [PATCH v7 1/4] timer: atmel_tcb_timer: add atmel_tcb driver Clément Léger
2022-03-11 9:35 ` [PATCH v7 2/4] ARM: dts: at91: sama5d2: add AIC node Clément Léger
2022-03-11 9:35 ` [PATCH v7 3/4] ARM: dts: at91: sama5d2: add TCB node Clément Léger
2022-03-11 9:35 ` [PATCH v7 4/4] configs: sama5d2: enable option CONFIG_ATMEL_TCB_TIMER Clément Léger
2022-03-22 11:18 ` Eugen.Hristev [this message]
2022-03-22 12:35 ` Clément Léger
2022-03-30 15:49 ` Clément Léger
2022-03-31 5:59 ` Eugen.Hristev
2022-03-31 7:40 ` Clément Léger
2022-03-31 7:53 ` Eugen.Hristev
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=c5fef41b-51b2-ead4-96c2-eb8f23a3f459@microchip.com \
--to=eugen.hristev@microchip.com \
--cc=Claudiu.Beznea@microchip.com \
--cc=Ludovic.Desroches@microchip.com \
--cc=Nicolas.Ferre@microchip.com \
--cc=clement.leger@bootlin.com \
--cc=thomas.petazzoni@bootlin.com \
--cc=u-boot@lists.denx.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox