Re: [PATCH v2 4/5] verdin-imx8mm: various config additions and improvements

[Stefano Babic <sbabic@denx.de>]

On 18.09.22 22:41, sbabic@denx.de wrote:
>> From: Marcel Ziswiler <marcel.ziswiler@toradex.com>
>> - integrate bootcount using SNVS_LP general purpose register LPGPR0
>> - enable link-time optimisation
>> - explicitly set a boot delay of one second
>> - enable CRC32 and MD5
>> - enable command for low-level access to data in a partition
>> - enable time commands
>> - enable PMIC commands
>> - improve ETHPRIME configuration
>> - enable eMMC HS400 functionality
>> - enable fixed PHY and MDIO driver model
>> - remove stale PFUZE100 PMIC driver
>> - enable thermal management unit driver
>> - enable more USB host functionality
>> - enable hexdump
>> Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
> Applied to u-boot-imx, master, thanks !
> 

Not yet: Patch 4/5 and 5/5 require a rebase, I avoid to do it myself as 
I cannot then test if it is ok. These two patches are not in my PR, I 
can pick them up if you repost them.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, 82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic@denx.de
=====================================================================