From mboxrd@z Thu Jan  1 00:00:00 1970
From: Amit Shah <amitshah@gmx.net>
Date: Wed, 07 Jul 2004 14:19:38 +0530
Subject: [U-Boot-Users] Re: getting u-boot on the mv64360
References: <ccebh8$j6f$1@sea.gmane.org> <20040706172916.5EB05C109F@atlas.denx.de>
Message-ID: <ccgdj3$dio$1@sea.gmane.org>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Hi Wolfgang,

Wolfgang Denk wrote:

> In message <ccebh8$j6f$1@sea.gmane.org> you wrote:
>> 
>> I have an MV64360 board (IBM dev brd), that has PIBS on it. What's the
>> best way to use u-boot with it?
> 
> Erase PIBS and install U-Boot instead ;-)

heh, I would, if I had an exit-route in case u-boot didn't work for some
reason (linker script fsck-up, etc.)

>> I compiled u-boot with powepc-gcc-3.3.4 (compiled via crosstool), but
>> PIBS fails to load the binary (.bin). (In fact, PIBS doesn't recognize
>> any of the binaries).
> 
> Then find out what PIBS expects.

Yes, but even putting the modified PIBS on the board is scary... w/o a BDI.
The docs say it supports .bin files, but the sources don't. It says it
supports ELF, but hangs on some relocation. No idea where it dies.. it just
stalls.

>> So what's the recommended way? Should I put u-boot on the flash,
>> overwriting
> 
> Yes.
> 
>> PIBS? And since I don't have a BDI cable, how can I put u-boot on the
>> board?
> 
> Get a BDI2000; the box also includes the required cable.

Yup; I hope the "higher levels" clear it soon enough ;-)

> 
> 
> Best regards,
> 
> Wolfgang Denk
> 

Thanks,
Amit.

-- 
Amit Shah
http://amitshah.nav.to/