From mboxrd@z Thu Jan 1 00:00:00 1970 From: Harald Seiler Date: Wed, 4 Mar 2020 15:23:09 +0100 Subject: [PATCH 0/3] ARM: Fix reset in SPL if SYSRESET is not used Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hello, continuing on the discussion around Claudius' patch for fixing reset in SPL [1] we have taken a closer look at the issue. To quickly summarize the situation: The original patch was to enable the generic ARM implementation of `do_reset` if CONFIG_SYSRESET is not enabled in SPL. This would break compilation for some boards which define their own `do_reset` in `board/*/spl.c`. To be more specific, the following 4 boards have this custom `do_reset`: - toradex/verdin-imx8mm - freescale/imx8mn_evk - freescale/imx8mm_evk - freescale/imx8mp_evk I hope we can all agree that `do_reset` is not at all meant to be implemented in board files. From looking at the related code for imx8m, it feels like this was just a workaround hack to archieve the same thing which Claudius has fixed. So this patch series reverts the addition of `do_reset` implementations in imx8m board files and instead switches to using the proper fix provided by Claudius. Additionally, the custom do_reset implementations were passing an address (WDOG1_BASE_ADDR) to `reset_cpu()` instead of 0. This is the only place in the entire U-Boot tree where this happens. Instead, all other implementations simply ignore the parameter and 0 is passed by callers. It looks a lot like this is a legacy left-over which makes me think that using it for a (hard-coded) watchdog address is not a good idea as it breaks convention with the rest of U-Boot. [1]: https://patchwork.ozlabs.org/patch/1201959 Claudius Heine (3): ARM: reset: use do_reset in SPL/TPL if SYSRESET was not enabled for them imx: imx8m*: Remove do_reset from board files imx: imx8m: Don't use the addr parameter of reset_cpu arch/arm/lib/Makefile | 2 +- arch/arm/mach-imx/imx8m/soc.c | 5 +---- board/freescale/imx8mm_evk/spl.c | 9 --------- board/freescale/imx8mn_evk/spl.c | 9 --------- board/freescale/imx8mp_evk/spl.c | 9 --------- board/toradex/verdin-imx8mm/spl.c | 9 --------- 6 files changed, 2 insertions(+), 41 deletions(-) -- Harald DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-62 Fax: +49-8142-66989-80 Email: hws at denx.de