* [U-Boot] [v3 0/2] Add support for new SoC APM82XXX
@ 2010-09-08 0:18 tmarri at apm.com
2010-09-08 2:00 ` Tirumala Marri
0 siblings, 1 reply; 2+ messages in thread
From: tmarri at apm.com @ 2010-09-08 0:18 UTC (permalink / raw)
To: u-boot
From: Tirumala Marri <tmarri@apm.com>
APM8XXXX is Applied Micro Circuits Corporations naming
convention for new line of SoCs.
V1:
* Squash some of the patches.
* add space between "||" and "\".
* Add spaces around operators.
* Unsigned int to u32.
* Add empty line which was removed.
* remove warning "unused variable" in cpu_init.c
* Remove "All rights reserved" phrase from headers.
* Add empty line which was removed.
* Move EBC definititions to bluestone_config.h file
* Remove reconfigure_EBC() function.
* Remove unused CONFIG_SDRAM16BIT_OFFSET.
* Remove unused CONFIG_SDRAM_INFO_EEPROM_ADDR.
* Add empty lines in bluestone.c file.
* Replacing AC_R | AC_W | AC_X with AC_RWX.
* Remove changes to main Makefile
* Remove NAND references from config file.
* Squash some of the patches.
* Remove top Makefile change.
V2:
* Missing space before "<".
* SDR_AHB_CFG not used, remove.
* boot device dfinitions are board specific ? removed.
* APM82161_MASK not used, remove
* set_mcsr() is already called in ddr init, no need to call here.
* removed finding bootdevice function which is not used.
* Add spaces in tlbentry() function.
* Board early init function is empty remove.
* Remove CONFIG_SYS_EXTSRAM_BASE.
* Set CONFIG_SYS_FLASH_SIZE to 4MB
* Remove CONFIG_SIZE_REDUCE & CONFIG_SECTOR_REDUCE.
* Spaces around " >> " .
* Correct the phy name CONFIG_M88E1111_PHY to CONFIG_RTL8211CL_PHY.
* Removed Defines added to 405ex.
V3:
* Missing TLB entry for CONFIG_SYS_BOOT_BASE_ADDR.
* Correct multiline comment.
* Move CONFIG_SYS_EBC_PB0AP etc to EBC area in the config file.
* remove unused CONFIG_RTL8211CL_PHY.
* Replace hard coded valued for CONFIG_SYS_EBC_CFG with
macro definitions.
* board.cfg add the entry in sorted.
* use puts() if there is no formating needed.
* Change APM82XXX to APM821XX
* Modify the way cpu id is printed.
* Correct inadvertent change.
* Sort define list.
* Remove comment for get_sys_info().
* Define a symbolic constat ISRAM1_OCM_SIZE.
* Create apm821xx.h instead of using ppc440.h
Tirumala Marri (2):
APM821xx: Add CPU support
APM821xx: Add bluestone board support
MAINTAINERS | 3 +
MAKEALL | 1 +
arch/powerpc/cpu/ppc4xx/cpu.c | 36 ++-
arch/powerpc/cpu/ppc4xx/cpu_init.c | 5 +-
arch/powerpc/cpu/ppc4xx/speed.c | 76 +++++-
arch/powerpc/cpu/ppc4xx/start.S | 11 +-
arch/powerpc/cpu/ppc4xx/tlb.c | 2 +
arch/powerpc/include/asm/ppc4xx-ebc.h | 4 +
arch/powerpc/include/asm/ppc4xx-isram.h | 14 +-
arch/powerpc/include/asm/ppc4xx-sdram.h | 12 +-
arch/powerpc/include/asm/ppc4xx-uic.h | 5 +-
arch/powerpc/include/asm/processor.h | 1 +
board/amcc/bluestone/Makefile | 52 ++++
board/amcc/bluestone/bluestone.c | 111 +++++++
board/amcc/bluestone/config.mk | 40 +++
board/amcc/bluestone/init.S | 59 ++++
boards.cfg | 1 +
include/apm821xx.h | 493 +++++++++++++++++++++++++++++++
include/configs/bluestone.h | 175 +++++++++++
include/ppc4xx.h | 11 +-
20 files changed, 1087 insertions(+), 25 deletions(-)
create mode 100644 board/amcc/bluestone/Makefile
create mode 100644 board/amcc/bluestone/bluestone.c
create mode 100644 board/amcc/bluestone/config.mk
create mode 100644 board/amcc/bluestone/init.S
create mode 100644 include/apm821xx.h
create mode 100644 include/configs/bluestone.h
^ permalink raw reply [flat|nested] 2+ messages in thread
* [U-Boot] [v3 0/2] Add support for new SoC APM82XXX
2010-09-08 0:18 [U-Boot] [v3 0/2] Add support for new SoC APM82XXX tmarri at apm.com
@ 2010-09-08 2:00 ` Tirumala Marri
0 siblings, 0 replies; 2+ messages in thread
From: Tirumala Marri @ 2010-09-08 2:00 UTC (permalink / raw)
To: u-boot
Please ignore this series. I missed "PATCH" string. I will resend the
correct patch set.
--Marri
> -----Original Message-----
> From: tmarri at apm.com [mailto:tmarri at apm.com]
> Sent: Tuesday, September 07, 2010 5:19 PM
> To: u-boot at lists.denx.de
> Cc: sr at denx.de; Tirumala Marri
> Subject: [v3 0/2] Add support for new SoC APM82XXX
>
> From: Tirumala Marri <tmarri@apm.com>
>
> APM8XXXX is Applied Micro Circuits Corporations naming
> convention for new line of SoCs.
>
> V1:
> * Squash some of the patches.
> * add space between "||" and "\".
> * Add spaces around operators.
> * Unsigned int to u32.
> * Add empty line which was removed.
> * remove warning "unused variable" in cpu_init.c
> * Remove "All rights reserved" phrase from headers.
> * Add empty line which was removed.
> * Move EBC definititions to bluestone_config.h file
> * Remove reconfigure_EBC() function.
> * Remove unused CONFIG_SDRAM16BIT_OFFSET.
> * Remove unused CONFIG_SDRAM_INFO_EEPROM_ADDR.
> * Add empty lines in bluestone.c file.
> * Replacing AC_R | AC_W | AC_X with AC_RWX.
> * Remove changes to main Makefile
> * Remove NAND references from config file.
> * Squash some of the patches.
> * Remove top Makefile change.
>
> V2:
> * Missing space before "<".
> * SDR_AHB_CFG not used, remove.
> * boot device dfinitions are board specific ? removed.
> * APM82161_MASK not used, remove
> * set_mcsr() is already called in ddr init, no need to call here.
> * removed finding bootdevice function which is not used.
> * Add spaces in tlbentry() function.
> * Board early init function is empty remove.
> * Remove CONFIG_SYS_EXTSRAM_BASE.
> * Set CONFIG_SYS_FLASH_SIZE to 4MB
> * Remove CONFIG_SIZE_REDUCE & CONFIG_SECTOR_REDUCE.
> * Spaces around " >> " .
> * Correct the phy name CONFIG_M88E1111_PHY to CONFIG_RTL8211CL_PHY.
> * Removed Defines added to 405ex.
>
> V3:
> * Missing TLB entry for CONFIG_SYS_BOOT_BASE_ADDR.
> * Correct multiline comment.
> * Move CONFIG_SYS_EBC_PB0AP etc to EBC area in the config file.
> * remove unused CONFIG_RTL8211CL_PHY.
> * Replace hard coded valued for CONFIG_SYS_EBC_CFG with
> macro definitions.
> * board.cfg add the entry in sorted.
> * use puts() if there is no formating needed.
> * Change APM82XXX to APM821XX
> * Modify the way cpu id is printed.
> * Correct inadvertent change.
> * Sort define list.
> * Remove comment for get_sys_info().
> * Define a symbolic constat ISRAM1_OCM_SIZE.
> * Create apm821xx.h instead of using ppc440.h
>
> Tirumala Marri (2):
> APM821xx: Add CPU support
> APM821xx: Add bluestone board support
>
> MAINTAINERS | 3 +
> MAKEALL | 1 +
> arch/powerpc/cpu/ppc4xx/cpu.c | 36 ++-
> arch/powerpc/cpu/ppc4xx/cpu_init.c | 5 +-
> arch/powerpc/cpu/ppc4xx/speed.c | 76 +++++-
> arch/powerpc/cpu/ppc4xx/start.S | 11 +-
> arch/powerpc/cpu/ppc4xx/tlb.c | 2 +
> arch/powerpc/include/asm/ppc4xx-ebc.h | 4 +
> arch/powerpc/include/asm/ppc4xx-isram.h | 14 +-
> arch/powerpc/include/asm/ppc4xx-sdram.h | 12 +-
> arch/powerpc/include/asm/ppc4xx-uic.h | 5 +-
> arch/powerpc/include/asm/processor.h | 1 +
> board/amcc/bluestone/Makefile | 52 ++++
> board/amcc/bluestone/bluestone.c | 111 +++++++
> board/amcc/bluestone/config.mk | 40 +++
> board/amcc/bluestone/init.S | 59 ++++
> boards.cfg | 1 +
> include/apm821xx.h | 493
> +++++++++++++++++++++++++++++++
> include/configs/bluestone.h | 175 +++++++++++
> include/ppc4xx.h | 11 +-
> 20 files changed, 1087 insertions(+), 25 deletions(-)
> create mode 100644 board/amcc/bluestone/Makefile
> create mode 100644 board/amcc/bluestone/bluestone.c
> create mode 100644 board/amcc/bluestone/config.mk
> create mode 100644 board/amcc/bluestone/init.S
> create mode 100644 include/apm821xx.h
> create mode 100644 include/configs/bluestone.h
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2010-09-08 2:00 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2010-09-08 0:18 [U-Boot] [v3 0/2] Add support for new SoC APM82XXX tmarri at apm.com
2010-09-08 2:00 ` Tirumala Marri
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox