[U-Boot] [PATCH] zynq/board.c: Add support for qspiboot and nandboot

[Mike Looijmans <mike.looijmans@topic.nl>]

?Ah, missed that. I noticed that "run $modeboot" didn't work for QSPI in the 
2017.1 tag, hadn't seen that one yet.

On 13-01-17 14:18, Michal Simek wrote:
> Hi,
>
> On 13.1.2017 14:04, Mike Looijmans wrote:
>> The Zynq can also boot from QSPI or NAND, and environment scripting
>> uses "qspiboot" and "nandboot" already. Add these to the board init
>> routines so that modeboot is properly set to one of these values when
>> the mode bits indicate so.
>>
>> Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
>> ---
>>  board/xilinx/zynq/board.c | 6 ++++++
>>  1 file changed, 6 insertions(+)
>>
>> diff --git a/board/xilinx/zynq/board.c b/board/xilinx/zynq/board.c
>> index 5cd9bbf..cf80302 100644
>> --- a/board/xilinx/zynq/board.c
>> +++ b/board/xilinx/zynq/board.c
>> @@ -85,9 +85,15 @@ int board_init(void)
>>  int board_late_init(void)
>>  {
>>  	switch ((zynq_slcr_get_boot_mode()) & ZYNQ_BM_MASK) {
>> +	case ZYNQ_BM_QSPI:
>> +		setenv("modeboot", "qspiboot");
>> +		break;
>>  	case ZYNQ_BM_NOR:
>>  		setenv("modeboot", "norboot");
>>  		break;
>> +	case ZYNQ_BM_NAND:
>> +		setenv("modeboot", "nandboot");
>> +		break;
>>  	case ZYNQ_BM_SD:
>>  		setenv("modeboot", "sdboot");
>>  		break;
>>
>
> The same patch was merged some days ago. Please check latest master branch.
>
> Thanks,
> Michal
>



Kind regards,

Mike Looijmans
System Expert

TOPIC Products
Materiaalweg 4, NL-5681 RJ Best
Postbus 440, NL-5680 AK Best
Telefoon: +31 (0) 499 33 69 79
E-mail: mike.looijmans at topicproducts.com
Website: www.topicproducts.com

Please consider the environment before printing this e-mail