[U-Boot-Users] Re: PATCH: Add support for EmbeddedPlanet EP88x boards

[Will Haines <will.haines@embedded-sys.com>]

Will Haines <will.haines <at> embedded-sys.com> writes:

> Thank you for the patch.  The code should help me a lot.  However, when I tried
> to test it with my board and EP885C, I got no output to the terminal. 

I think that that specific error stemmed from my BDI configuration file;
however, I still cannot get the port to even print anything to the terminal.  My
steps for putting to the board are as follows:

make distclean
make EP8xx_config
make all

Then with the BDI:
erase 0xfc000000
erase 0xfc020000
prog u-boot.bin bin
reset

When I reboot the board there is no output to the console.

When I try to run this using the debugger it appears that things work correctly
until the intialization gets trapped in speed.c's function: init_pll_866.  I
have no idea why a function with no loops in it would seem to loop forever.  My
only idea is that something is going wrong with plprcr_write_866's return jump.

Any suggestions at all to get this port running on my board would be much
appreciated!

Will Haines