[U-Boot] [PATCH V2 2/2] da850: Enable SPI Flash

Ben Gardiner
2010-11-12T17:26:18Z

On Fri, Nov 12, 2010 at 11:38 AM, Stefano Babic <sbabic@denx.de> wrote:
> The patch was already posted to the arago project,
> but not yet to mainline, with the following message:
>
> da850: Enable SPI in configuration file
>
> It allows to save environment into the spi flash.
> Tested on LogiPD tmdxl138 board.
>
> Signed-off-by: Sudhakar Rajashekhara <sudhakar.raj@ti.com>
> Signed-off-by: Stefano Babic <sbabic@denx.de>
> CC: Detlev Zundev <dzu@denx.de>
> Tested-by: Ben Gardiner <bengardiner@nanometrics.ca>
> ---
> Changed since V1:
> ?- commit message contains original message from Arago project
> ? (Detlev Zundev)
> ?- protect SPI definitions with #CONFIG_USE_SPIFLASH
> ? (Ben Gardiner)

Thanks, Stefano.

This version is still good for me.

Best Regards,
Ben Gardiner

---
Nanometrics Inc.