[U-Boot-Users] [PATCH 7/8] ppc4xx: Remove superfluous dram_init() call or replace it by initdram()

[Detlev Zundel <dzu@denx.de>]

Hi Stefan,

> Historically the 405 U-Boot port had a dram_init() call in early init
> stage. This function was still called from start.S and most of the time
> coded in assembler. This is not needed anymore (since a long time) and
> boards should implement the common initdram() function in C instead.
>
> This patch now removed the dram_init() call from start.S and removes the
> empty implementations that are scattered through most of the 405 board
> ports. Some older board ports really implement this dram_init() though.
> These are:
>
> csb272
> csb472
> ERIC
> EXBITGEN
> W7OLMC
> W7OLMG
>
> I changed those boards to call this assembler dram_init() function now
> from their board specific initdram() instead. This *should* work, but please
> test again on those platforms. And it is perhaps a good idea that those
> boards use some common 405 SDRAM initialization code from cpu/ppc4xx at
> some time. So further patches welcome here.
>
> Signed-off-by: Stefan Roese <sr@denx.de>

I put those maintainers that I could find on CC to inform them.  You
could have done the same ;)

ERIC and W70LMC, W70LMG don't have maintainer entries...

Cheers
  Detlev

-- 
You see, the best way to solve a problem is to rigorously define it in
terms of other people's problems, and then run away quickly.
                                          -- Roland McGrath
--
DENX Software Engineering GmbH,      MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich,  Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-40 Fax: (+49)-8142-66989-80 Email: dzu at denx.de