From mboxrd@z Thu Jan 1 00:00:00 1970 From: Detlev Zundel Date: Thu, 28 Oct 2010 12:52:31 +0200 Subject: [U-Boot] [PATCH 3/3 V3] Add board support for hawkboard In-Reply-To: <1288115885-4933-1-git-send-email-urwithsughosh@gmail.com> (Sughosh Ganu's message of "Tue, 26 Oct 2010 23:28:05 +0530") References: <1288115885-4933-1-git-send-email-urwithsughosh@gmail.com> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi Sughosh, [...] > * hawkboard_nand_config - Used to generate the secondary > bootloader(nand_spl) image. This creates an elf file u-boot-spl > under nand_spl/. Create an AIS signed image using this file, and > flash it to the nand flash at address 0x20000. The ais file should > fit in one block. Could you elaborate on "create an AIS signed image" a little bit for people who are not intimately familiar with this architecture? Maybe you can add a small doc/README.da8xx for that purpose? > * hawkboard_uart_config - This is same as the first image, but with > the TEXT_BASE as expected by the RBL(0xc1080000). Create the AIS > Signed bin, as use the normal UART boot procedure to boot the image. Again a short step-by-step instruction in a readme file would be a very valuable addition. Thanks Detlev -- UN Resolution by the General Assembly on December 31, 1988 condemning "Terrorism Wherever and by Whomever Committed": 153 votes to 2. The two voting /against/ the resolution were the US and Israel... -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-40 Fax: (+49)-8142-66989-80 Email: dzu at denx.de