From mboxrd@z Thu Jan 1 00:00:00 1970 From: Christophe Jauffret Date: Tue, 28 Nov 2000 16:02:15 +0000 Subject: scsi on ultra 1 problem Message-Id: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: ultralinux@vger.kernel.org i have a sun ultra1/170E where i want install Linux and all the Kernel that i boot cause problem with scsi i test with 2.2.14-5 (from redhat 6.2), 2.2.17 custom (compiled with Linux on Ultra5), 2.4-pre11 custom (compiled with the same Ultra5) scsi controller seems be NCR53C9XF aka espfast my hard drive was Quantum ATLAS II and all my kernel say (this log is from 2.2.17): esp0: IRQ 3,7e0 SCSI ID 7 Clk 40MHz CCF=8 TOut 167 NCR53C9XF(espfast) ESP: Total of 1 ESP hosts found, 1 actually in use. scsi0 : Sparc ESP366-HME scsi : 1 host. esp0: target 1 [period 100ns offset 15 20.00MHz FAST-WIDE SCSI-II] esp0: data bad parity detected. esp0: yieee, bytes_sent < 0! esp0: csz=0 fifocount=0 ecounte520 esp0: use_sg=0 ptr00000013006b88 this_residual=0 esp0: Forcing async for target 1 scsi0 : channel 0 target 1 lun 0 request sense failed, performing reset. SCSI bus is being reset for host 0 channel 0. esp0: Resetting scsi bus esp0: SCSI bus reset interrupt esp0: target 1 [period 100ns offset 15 20.00MHz FAST-WIDE SCSI-II] esp0: data bad parity detected. esp0: data bad parity detected. esp0: yieee, bytes_sent < 0! esp0: csz=0 fifocount=0 ecounte520 esp0: use_sg=0 ptr00000013006b88 this_residual=0 esp0: Forcing async for target 1 scsi0 : channel 0 target 1 lun 0 request sense failed, performing reset. SCSI bus is being reset for host 0 channel 0. esp0: Resetting scsi bus esp0: SCSI bus reset interrupt esp0: target 1 [period 100ns offset 15 20.00MHz FAST-WIDE SCSI-II] esp0: data bad parity detected. esp0: data bad parity detected. esp0: data bad parity detected. scsi : aborting command due to timeout : pid 7, scsi0, channel 0, id 6, lun 0 R esp0: Aborting command esp0: dumping state esp0: dma -- cond_reg addr<13006b78> esp0: SW [sreg<11> sstep<04> ireg<18>] ---------------------------------------------------------- end of log ---------------------------------------------------------- we see the "data bad parity detected" like some other people on this mailinglist but no response found all idea are welcome - To unsubscribe from this list: send the line "unsubscribe ultralinux" in the body of a message to majordomo@vger.kernel.org