[virtio-dev] [PATCH] content: Replace guest OS with driver

[Parav Pandit <parav@nvidia.com>]

Currently device status field description and driver requirements
section uses mix of terminology for the driver. These two sections
sometimes call the driver as 'the guest OS' or 'the driver'.

Most of the cleanup around 'guest Os' was already done around commit
212c0cf3 in past. Clean up the remaining few references to just
refer it as 'driver'.

This is an editorial change.

Signed-off-by: Parav Pandit <parav@nvidia.com>
---
 content.tex | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/content.tex b/content.tex
index 9df81b8..417d476 100644
--- a/content.tex
+++ b/content.tex
@@ -26,10 +26,10 @@ \section{\field{Device Status} Field}\label{sec:Basic Facilities of a Virtio Dev
 following bits are defined (listed below in the order in which
 they would be typically set):
 \begin{description}
-\item[ACKNOWLEDGE (1)] Indicates that the guest OS has found the
+\item[ACKNOWLEDGE (1)] Indicates that the driver has found the
   device and recognized it as a valid virtio device.
 
-\item[DRIVER (2)] Indicates that the guest OS knows how to drive the
+\item[DRIVER (2)] Indicates that the driver knows how to drive the
   device.
   \begin{note}
     There could be a significant (or infinite) delay before setting
@@ -473,13 +473,13 @@ \section{Device Initialization}\label{sec:General Initialization And Device Oper
 \begin{enumerate}
 \item Reset the device.
 
-\item Set the ACKNOWLEDGE status bit: the guest OS has noticed the device.
+\item Set the ACKNOWLEDGE status bit: the driver has noticed the device.
 
-\item Set the DRIVER status bit: the guest OS knows how to drive the device.
+\item Set the DRIVER status bit: the driver knows how to drive the device.
 
 \item\label{itm:General Initialization And Device Operation /
 Device Initialization / Read feature bits} Read device feature bits, and write the subset of feature bits
-   understood by the OS and driver to the device.  During this step the
+   understood by the driver to the device.  During this step the
    driver MAY read (but MUST NOT write) the device-specific configuration fields to check that it can support the device before accepting it.
 
 \item\label{itm:General Initialization And Device Operation / Device Initialization / Set FEATURES-OK} Set the FEATURES_OK status bit.  The driver MUST NOT accept
-- 
2.26.2


---------------------------------------------------------------------
To unsubscribe, e-mail: virtio-dev-unsubscribe@lists.oasis-open.org
For additional commands, e-mail: virtio-dev-help@lists.oasis-open.org