[PATCH v4 4/7] xen/arm: move setup_mm right after setup_pagetables

[Stefano Stabellini <stefano.stabellini@eu.citrix.com>]

At the moment we destroy the DTB mappings we have in setup_pagetables
and we restore them only in setup_mm.

Move setup_mm right after setup_pagetables so that we don't leave over
portions of the initialization code without a working DTB mapping.

Signed-off-by: Stefano Stabellini <stefano.stabellini@eu.citrix.com>
---
 xen/arch/arm/setup.c |    3 +--
 1 files changed, 1 insertions(+), 2 deletions(-)

diff --git a/xen/arch/arm/setup.c b/xen/arch/arm/setup.c
index 2076724..8882514 100644
--- a/xen/arch/arm/setup.c
+++ b/xen/arch/arm/setup.c
@@ -212,6 +212,7 @@ void __init start_xen(unsigned long boot_phys_offset,
     cmdline_parse(device_tree_bootargs(fdt));
 
     setup_pagetables(boot_phys_offset, get_xen_paddr());
+    setup_mm(atag_paddr, fdt_size);
 
 #ifdef EARLY_UART_ADDRESS
     /* TODO Need to get device tree or command line for UART address */
@@ -229,8 +230,6 @@ void __init start_xen(unsigned long boot_phys_offset,
 
     init_xen_time();
 
-    setup_mm(atag_paddr, fdt_size);
-
     /* Setup Hyp vector base */
     WRITE_CP32((uint32_t) hyp_traps_vector, HVBAR);
     printk("Set hyp vector base to %"PRIx32" (expected %p)\n",
-- 
1.7.2.5