Re: [PATCH] xen: arm: platforms: Remove determining reset specific values from dts for XGENE.

[Ian Campbell <Ian.Campbell@citrix.com>]

On Wed, 2014-02-05 at 14:57 +0000, George Dunlap wrote:
> On 02/04/2014 09:43 AM, Ian Campbell wrote:
> > On Tue, 2014-02-04 at 11:35 +0530, Pranavkumar Sawargaonkar wrote:
> >> This patch removes reading reset specific values (address, size and mask) from dts
> >> and uses values defined in the code now.
> >> This is because currently xgene reset driver (submitted in linux) is going through
> >> a change (which is not yet accepted), this new driver has a new type of dts bindings
> >> for reset.
> >> Hence till linux driver comes to some conclusion, we will use hardcoded values instead
> >> of reading from dts so that xen code will not break due to the linux transition.
> >>
> >> Ref:
> >> http://lists.xen.org/archives/html/xen-devel/2014-01/msg02256.html
> >> http://www.gossamer-threads.com/lists/linux/kernel/1845585
> >>
> >> Signed-off-by: Pranavkumar Sawargaonkar <pranavkumar@linaro.org>
> >> Signed-off-by: Anup Patel <anup.patel@linaro.org>
> > Acked-by: Ian Campbell <ian.campbell@citrix.com>
> >
> > George -- I'd like to take this into 4.4 to avoid shipping a Xen which
> > relies on an unagreed DTS binding (which is an ABI of sorts).
> 
> Is this the reboot binging one with 3 options, #2 of which was hard-code 
> the values rather than using DT?
> 
> Assuming so:
> 
> Release-acked-by: George Dunlap <george.dunlap@eu.citrix.com>

Applied, thanks all.

I reflowed the commit message to make it fit in 80 columns.