Thanks for the istructions,
I have read that thread but is not useful for me. I have compiled and
installed the round robin scheduler of that thread. Both schedulers have the
same behavior. Following your advice I have set up a serial console. I have
attached serial console's log along with this mail. As I supposed, dom0
doesn't start.

Michele

On Mon, Feb 15, 2010 at 7:54 PM, Pasi Kärkkäinen <pasik@iki.fi> wrote:

> On Mon, Feb 15, 2010 at 01:59:06PM +0000, George Dunlap wrote:
> > Do you have a serial console set up?
> >
>
> If not, instructions here:
> http://wiki.xensource.com/xenwiki/XenSerialConsole
>
> -- Pasi
>
> > You may want to skim this thread:
> >
> http://lists.xensource.com/archives/html/xen-devel/2009-04/msg01086.html
> > to see if any of the advice given there is useful.
> >
> >  -George
> >
> > On Mon, Feb 15, 2010 at 1:19 PM, michele.paolino
> > <michele.paolino@studio.unibo.it> wrote:
> > > Hi! I'm writing a simple scheduler to study the xen scheduler
> interfaces.
> > > I am able to compile and install it. After reboot when I try to select
> > > sched=simple, the system gets ready to boot and then everything goes
> blank.
> > > I think that dom0 don't start. I can't be able to solve this problem,
> can
> > > anybody help me?
> > > I have attached my simple scheduler code along with this mail.
> > >
> > > Thanks,
> > > Michele
> > >
> > > _______________________________________________
> > > Xen-devel mailing list
> > > Xen-devel@lists.xensource.com
> > > http://lists.xensource.com/xen-devel
> > >
> > >
> >
> > _______________________________________________
> > Xen-devel mailing list
> > Xen-devel@lists.xensource.com
> > http://lists.xensource.com/xen-devel
>